My Orders
- Home
- FUM17DMARWH
- Instructions
FUM17DMARWH General Electric Freezer - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Gasket not sealing
2 of 2 people
found this instruction helpful.
-
Hazel from FRIENDSWOOD, TX
- Difficult
- 30 - 60 mins
-
Screw drivers
Per the UTube video ...
Once the gasket was on, the door would not seal.
Gasket was removed and placed in dryer again to "soften" but to no avail on the second try.
When we received the package, the box was ripped open and only the wadded up gasket in the box. Don't know if someone just shoved it in or what. I think thi ... Read more s is what caused the issue with it not sealing. Also no instructions except on your website. We ended up putting on the original gasket and sealed the cut on the gasket with tape. Freezer seals well and no leaks or issues. I still have the gas but no clue what to do with it if we can't get it to work. Is there a refund available?
Once the gasket was on, the door would not seal.
Gasket was removed and placed in dryer again to "soften" but to no avail on the second try.
When we received the package, the box was ripped open and only the wadded up gasket in the box. Don't know if someone just shoved it in or what. I think thi ... Read more s is what caused the issue with it not sealing. Also no instructions except on your website. We ended up putting on the original gasket and sealed the cut on the gasket with tape. Freezer seals well and no leaks or issues. I still have the gas but no clue what to do with it if we can't get it to work. Is there a refund available?
Read less
Was this helpful?
Thank you for voting!
Tempture Got Hot In Box. The Compressor Was Making A Clicking Sound.
1 person
found this instruction helpful.
-
Jerry from Marion, KY
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
First I tested the compressor with my v. O. Meter and it was ok I then found the relay was bad I removed the start relay by puling it off the compressor & removed the run wire & start wire watching not to cross them & reversed to re install. Now it runs good again.
Was this helpful?
Thank you for voting!