FPD14TFF0 Frigidaire Refrigerator - Instructions

Took old defrost pan off, put new one on. Had to bend new defrost pan a little for it to fit..

just had to loosen the old, broken piece, and snap in the replacement. Piece of cake

Snapped in missing brackets, cut bar to fit and installed.

Replaced the old end cap with the new one. Took less than a minute.

snapped in the one end, placed the bar in one end and the other clip on the other end and snapped it in place.

Refrigerator started frosting up and running all the time.I'd defrost it and it would frost up again in about a week.The timer seems to be work so I just guest it mite be the Defrost Thermostat.I removed the duck in the center and back panel in the freezer compartment defrosted it and switched Thermostats and replaced panel and duck, going to lower compartment of the refrigerator.So far it seems to be working a little more time while tell.

Snapped the end caps onto the existing shelf, and eased the assembly into the door slots. Light tapping with a hammer was required to fully seat the assembly into the door. All in all, a straightforward and simple repair.

replaced it

The door shelves in the freezer door of my Frigidaire refrigerator were broken, rendering the shelves useless. I ordered four (4) end caps from PartSelect. The end caps arrived in about five days. I attached the caps to the ends of the door shelves and popped them into the slots on the door. It was a very easy repair!.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Cleaned insert hole, did a dry-run, then pressed everything permanently in place.

Slipped out the end caps with the broken prongs from the front rack and slipped in the new end caps. (3 mins.)

I slid the new end cap onto the bar and snapped the bar back into place.

Unplugged refrigerator. Removed control knob and cover. Unwired control and removed same. Removed plastic tube from old capillary tube and placed on new unit. Installed and wired in new unit, making sure new unit was in the "off" position. Plugged in refrigerator, turned control knob to the first numerical setting, and was rewarded with the startup of the refrigerator compressor. Voila!

Emptied freezer, removed fan motor cover (2 screws), removed fan and motor (2 screws), removed old motor from bracket and reassembled with new motor, transferred fan blade from old motor to new), re-installed new fan/motor (2 screws) and reinstalled cover...