All Installation Instructions for Frigidaire Refrigerator FGUI2149LP5

The Refrigerator was not cooling properly. At 40-45 degrees milk spoiled

My upper and bottom air diffuser was missing.
Purchased both air diffuser and placed it.

Parts Used:

Bottom Air Diffuser

Marcos from E STROUDSBURG, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Rail had split and would not support drawer.

Removed drawer. Removed shelve. Flipped shelve over. Removed one screw. Undid tab on each end. Removed bad rail. Replaced with new rail and reversed order. Easy fix.

Parts Used:

Meat Drawer Rail - Right Side

Douglas from HOUSTON, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

torn and cracked gasket

Took off the old one, replace the new one in less than 5 minutes

Parts Used:

Refrigerator Door Gasket

janet from Parryville, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

crack

pull off the old gasket and push on the new one into the channel...

Parts Used:

Refrigerator Door Gasket

w l from PIKESVILLE, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

door gasket torn on top

followed installation video on your website which was very helpful. Very easy repair. The packing material was great.

Parts Used:

Refrigerator Door Gasket

James from FORESTDALE, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light Switch too loose so no longer triggered by the door.

Googled it on Youtube - unplugged the fridge, used a paint scraper to loosen the old light switch, unplugged it from the electrical source, connected the new switch, replaced the whole unit into the proper location and pushed it firmly into place.

Parts Used:

Light Switch

Linda from BOZEMAN, MT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old door seal was cracked and didn't seal tight.

Pulled off the old seal and put the new one on. No tools needed. It fit where it was supposed to and seals the door like new now! Thank you!

Parts Used:

Refrigerator Door Gasket

Rosemary from FRUITPORT, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

It was broken in the front part that hooked in the hole

Took the drawer and shelf out then took the screw out and took the old one out and then put the new one on.

Parts Used:

Meat Drawer Rail - Left Side

Harriet from LOCKWOOD, NY
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light Switch not working properly

After unplugging the fridge, I took a small flat headed screwdriver and carefully pried off the light switch from the inside, right side of the refrigerator. I disconnected the 2 wires from the switch and replaced it with the new switch and pushed it back into the frame of the fridge. Done !! Very very easy !! Thank you

Parts Used:

Light Switch

William from ORMOND BEACH, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Gasket was oversize and compression spline would not stay in door groove

Required a trip to the hardware store. Online research showed that Gorilla Glue would hold gasket in place and was recommended for that task. Needed to glue each side separately to keep the spline in the groove. Took far longer than it should have!

Parts Used:

GASKET-Freezer DOOR

CECIL from PHOENIXVILLE, PA
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Not making ice

Took out old replaced with new. Now it makes ice

Parts Used:

Ice Maker Fill Tube Assembly

Sam from Ravenswood, WV
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Water inlet valve stuck open

Turned off water to inlet valve. Unbolted valve from back of unit, disconnect water supply line from valve, disconnected water line to ice maker. Put on new compression ring around water supply line. Pressed ice maker line into new valve, installed valve back on unit, then connected main supply line to valve. Works like a charm.

Parts Used:

Water Inlet Valve

Robert from GUNTERSVILLE, AL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench (Adjustable)

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Scratch on stainless frig door.

Can't supply any info that would be helpful. Ordered a " badge" that covered 100% of the scratch and stuck it on. Scratch now covered and problem solved. Thanks for asking.

Parts Used:

Logo Badge

BETTY from SHINGLETOWN, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Cracked shelf

Snapped it in shelf in designated slots

Parts Used:

Refrigerator Door Shelf Bin

Leonard from WARRINGTON, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The light in freezer side of upright side by side went out.

I emptied freezer side of unit, turned unit off, rolled unit away from wall, unplugged unit, turned ice maker water supply off, and took out the ice maker. I then took out old light and replaced it with new light. I then plugged in the unit, turned on the water supply, rolled the unit back in place, placed the ice maker back in the unit and turned the unit back on.
After two hours I placed the frozen items back in the freezer.

Parts Used: