All Installation Instructions for Frigidaire Refrigerator FGUI2149LP3

bottom door seal won't seal right

R&R DOOR SEAL VERY EASY TO INSTALL THANKS TO ALL

Parts Used:

MANUEL from LOS ANGELES, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker would dump ice one time and then stop. Turning the ice maker off for a minute and back on would repeat the process.

I removed the two side mount screws with a screwdriver and disconnected the electrical plug to the ice maker to remove it. I reversed the process to install the new one.

It was the thermostat that was the problem, but I chose to replace the entire ice maker for only $25 more.

Parts Used:

Refrigerator Ice Maker Assembly

James from KNOXVILLE, TN
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker stopped working. Part needed to repair it no longer available so had to replace the whole icemaker.

Loosened the two mounting screws (no need to remove them), lift off the icemaker and unplug it. Reverse the order and done.

Parts Used:

Refrigerator Ice Maker Assembly

Edward from GROTON, CT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

i smell very bad smell coming from refrigerator

I started look inside ,disconnected power, and open all possible compartments to see any burned part. Fortunately I fined a small part look like melted and then i went online and make my research .Then i ordered that part and change it.

Parts Used:

Defrost Thermostat

Arsen from Glendale, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

7 of 16 people found this instruction helpful.

Was this instruction helpful to you?

Not making ice

Took out old replaced with new. Now it makes ice

Parts Used:

Ice Maker Fill Tube Assembly

Sam from Ravenswood, WV
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light Switch not working properly

After unplugging the fridge, I took a small flat headed screwdriver and carefully pried off the light switch from the inside, right side of the refrigerator. I disconnected the 2 wires from the switch and replaced it with the new switch and pushed it back into the frame of the fridge. Done !! Very very easy !! Thank you

Parts Used:

Light Switch

William from ORMOND BEACH, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

It was broken in the front part that hooked in the hole

Took the drawer and shelf out then took the screw out and took the old one out and then put the new one on.

Parts Used:

Meat Drawer Rail - Left Side

Harriet from LOCKWOOD, NY
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old door seal was cracked and didn't seal tight.

Pulled off the old seal and put the new one on. No tools needed. It fit where it was supposed to and seals the door like new now! Thank you!

Parts Used:

Refrigerator Door Gasket

Rosemary from FRUITPORT, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Gasket was oversize and compression spline would not stay in door groove

Required a trip to the hardware store. Online research showed that Gorilla Glue would hold gasket in place and was recommended for that task. Needed to glue each side separately to keep the spline in the groove. Took far longer than it should have!

Parts Used:

GASKET-Freezer DOOR

CECIL from PHOENIXVILLE, PA
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

freezer cold and frosting up but refrigerator warm

inside the freezer compartment, remove four hex head screws from rear panel,lift panel forward and unplug wire assembly from panel. find old defrost thermostat attached to copper tube by clip on back of thermostat, unclip, snip two wires to thermostat, take new thermostat, strip 1/4"of wire from wires in freezer (thermostat is prestripped),insert light blue wire from thermostat and light blue wire from freezer into opposite ends of crimp connector and crimp securely. repeat with dark blue wires. set panel back in freezer,connect plug to back of panel, refasten screws and you are go to go! save yourself the price of a new refrigerator or $300 repair by repairman!

Parts Used:

Defrost Thermostat

Gary from SABINSVILLE, PA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

torn and cracked gasket

Took off the old one, replace the new one in less than 5 minutes

Parts Used:

Refrigerator Door Gasket

janet from Parryville, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

crack

pull off the old gasket and push on the new one into the channel...

Parts Used:

Refrigerator Door Gasket

w l from PIKESVILLE, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Rail had split and would not support drawer.

Removed drawer. Removed shelve. Flipped shelve over. Removed one screw. Undid tab on each end. Removed bad rail. Replaced with new rail and reversed order. Easy fix.

Parts Used: