This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing wate...
This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and u...
This silverware basket has been redesigned by the manufacture. This is a one piece basket that replaces a system of three baskets that snapped together. The new basket measures 16.88" x 8", has two li...
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. R...
If your dishwasher is leaking or not draining properly, you may need to replace the drain hose. The drain hose connects to the pump located below the lower spray arm and aids in proper dishwasher drai...
This door seal is for dishwashers.
Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door.
After installing the door seal, shut the dishwasher door and ...
This is a bracket, but it may also be known as a dishrack row clip, or simply a tine clip, and it is used in conjunction with your dishwasher. The purpose of this part is to fasten to the rack and the...
This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete i...
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
February 24, 2020
Doesn't turn on. I have power to dishwasher. Door latch switch works. No display at all. Most likely problem? Control board? Touch display? Is there a fuse?
For model number FGID2466QF4A
Hello Jim,
Thank you for your question. Our sources suggest that its likely a faulty control board under part PS11758074 for your model to fix the power issues for the dishwasher. We hope this helps.
I am looking for a sound proofing/insulating fabric that sits on top of the unit , before the countertop is mounted on top of it. Cannot seem to find it on your site!Thanks!
For model number FGID2466QF4A
Hi Daniela,
Thank you for your question. There is insulation that goes around the dishwasher. The part number for it is PS11703938. We hope this helps. Thank you and have a great day.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Shree
December 6, 2019
What is the part # of the bottom door seal?
For model number FGID2466QF4A
Hi Shree, this part is linked below. Thank you for your question and good luck with your repair!
Hello Richard, Thank you for the question. Depending on when you hear the noise, this could indicate the Valve is defective and worn and may need to be replaced. If you hear the noise during the fill cycle, we suggest replacing the Valve. We hope this helps!
Hi Tiffany,
Thank you for your question. The rinse aid cap for your dishwasher is only sold with the detergent dispenser. The part number listed under your model number for the detergent dispenser is PS11770487. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the arm falls off, the three pieces become separate. When you want to replace the spray arm, only one new part needs to be ordered because this part encompases all three components.
I removed old tub gasket, which the door presses against to make a seal, and put the new one in. Flat tip screwdriver was used to gently press gasket in.
The Fix App makes it easy to manage all your stuff in one place. Just snap a photo and we'll find and store your user manuals, receipts, and product information in one easy-to-find place!
"Like magic. I took a picture of the model number on my refrigerator, and the app identified it right away … Very convenient. I'm impressed." ★★★★★ - Clever Jeff