Models
>
FEX831CS0
FEX831CS0 Frigidaire Washer Dryer Combo - Overview
Sections of the FEX831CS0
[Viewing 8 of 8]
Manuals & Care Guides for FEX831CS0
Click to downloadInstall
Installation Instructions
(0.49MB)
Install
Installation Instructions
(0.70MB)
Manual
Owner's Manuals
(3.4MB)
Manual
Owner's Manuals
(2.03MB)
Care
Use and Care Manual
(0.67MB)
Wiring
Wiring Diagram
(0.29MB)
Keep searches simple, eg. "belt" or "pump".
Drum Support Bearing
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS418807
Manufacturer #: 131825900
If your dryer does not tumble, will not start, is noisy, or is leaving marks on your clothing, you may need to replace the drum support bearing. The drum is supported at the rear by a bearing, which a...
$8.96
Order within the next 8 hrs and your part ships today!
Drum Glide - White
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS5574052
Manufacturer #: 137513300
This white drum glide is used in a clothes dryer to ensure the front of the dryer drum is supported as it does rotations. *Please note: these are sold individually, however there are two of these in y...
$41.84
Order within the next 8 hrs and your part ships today!
Drive V-Belt
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS1146950
Manufacturer #: 134511600
This rubber V-style drive belt slips on the motor pulley to bring the basket to the required speed. If you notice a burning rubber smell or grinding noises coming from your washer, your washer does no...
$24.08
Order within the next 8 hrs and your part ships today!
Dryer Lint Screen
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS12585473
Manufacturer #: 5304516871
This dryer lint screen is for laundry centers.
Dryer lint screen captures lint and debris from the exhaust air flowing from the dryer.
Follow the instructions in the owner's manual when installing this part.
$43.42
Order within the next 8 hrs and your part ships today!
Thermal Limiter - Limit 220
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS419402
Manufacturer #: 134120900
The dryer thermal limiter, also known as a thermal fuse, blows the fuse to cut off power to the dryer when the dryer begins to overheat. Once the dryer reached 220 degrees Fahrenheit, the heat cuts ou...
$28.16
Order within the next 8 hrs and your part ships today!
Door Catch
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS418433
Manufacturer #: 131658800
The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, which allows the door...
$60.53
Order within the next 8 hrs and your part ships today!
Multi-Rib Drum Belt
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS3408299
Manufacturer #: 137292700
The multi-rib drum belt is also known as a drive belt and is a part for your dryer. The function of the drum belt is to attach to the motor pulley. It will then spin the drum as the motor rotates. Ove...
$17.06
Order within the next 8 hrs and your part ships today!
Lower Front Felt Seal with Adhesive
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS832645
Manufacturer #: 5303937183
The lower front felt seal with adhesive, also known as a drum felt seal, is used in dyers and allows the drum to easily glide on the front panel. For this repair project, you will need the following t...
$33.45
Order within the next 8 hrs and your part ships today!
Drain Pump - 120V 60 Hz.
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS7783938
Manufacturer #: 137221600
This is a 120 volt, 60 hertz drain pump that is manufactured to remove water from the tub of your washer once your clothes are washed. This part is the pump and motor assembly, which includes a red fl...
$141.86
Order within the next 8 hrs and your part ships today!
Timer Knob
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS418916
Manufacturer #: 131873304
This knob accepts a D-shaped shaft.
$63.38
Order within the next 8 hrs and your part ships today!
Dryer Drum Bearing Bracket
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS12579101
Manufacturer #: 131724301
This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing
$10.50
Order within the next 8 hrs and your part ships today!
Ball Hitch
In Stock
Order within the next 8 hrs and your part ships today!
PartSelect #: PS418736
Manufacturer #: 131777700
This ball hitch provides support to the drum located at the back wall of the dryer. This allows the drum to spin. The bearing may have gone bad and you might notice that the ball is cut off. The ball ...
$68.31
Order within the next 8 hrs and your part ships today!
Questions And Answers for FEX831CS0
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
James
December 15, 2019
The dryer has started making a high pitched squeal when turned on. At first, it was random and would go away after warmed up. But now, the screeching sound is continuous. The unit is over 10 years old, but has worked great until now. Your thoughts?
For model number FEX831CS0
Hello James, thank you for your question. That type of issue is usually caused by the PartSelect Number: PS3408299 belt and rear drum bearing PartSelect #: PS459829. I hope this helps!
5 people found this helpful.
Was this helpful?
Thank you for voting!
Rodd
February 4, 2020
Washing machine won’t automatically go through it’s cycles. It has to be turned manually.
For model number FEX831CS0
Hello Rodd, Thank you for the question. This sounds like the Timer PartSelect Number PS418697 is defective and will need to be replaced. We hope this helps.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Jan
February 13, 2020
Could you please tell me the capacity of the wash tub and the dryer? Also, two other issues. 1-. dryer makes loud screeching noise when turned on, then noise quites in a few minutes. what part would i need? since it's 15 years old i don't want to put too much into it. if i continue to use without replacing this part, will it cause furthur damage? 2-. i have taken dryer apart when i bought it used and cleaned lint out thoughly. it still leaves much lint on clothes. vent does collect well and properly seeled. lint chunks hand up in door, but lint still on clothes once they are dry. any possible solutions? thanks much.
For model number FEX831CS0
Hi Jan, thank you for your question. Both are 5.7 cu ft. For your dryer you may want to check your felt seals and your ball hitch bearing. It could be that one or all of those parts have worn out and just need to be replaced. If you are getting excessive lint on your clothes you may need to clean the filter with some hot soapy water. It might be that it is clogged. You may also want to check the inside ducts of the appliance and make sure there is no build up on lint inside of the dryer duct itself. Good luck with your repair.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Anthony
March 5, 2020
While the washer is agitating it is making a high pitched whinning noise?
For model number FEX831CS0
Hi Anthony, thank you for your question. You may want to check your pulley and your belt to see if they need replacing if you are getting a high pitched noise like that. Those parts will wear down over time and might need replacing. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Keirsten
March 9, 2020
My dryer won’t start, when i hit the button it makes a noise like it’s about to start. It also has a weird smell. What could this be?
For model number FEX831CS0
Hello, Thank you for your question. You will need to check into the door switch and control board. Those are typically the cause of this issue. We hope this helps.
Was this helpful?
Thank you for voting!
Common Symptoms of the FEX831CS0
[Viewing 21 of 21]Noisy
Fixed by
these parts
these parts
Show All
No heat or not enough heat
Fixed by
these parts
these parts
Show All
Will not tumble
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Will not drain
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Marks left on clothes
Fixed by
these parts
these parts
Show All
Will not agitate
Fixed by
these parts
these parts
Show All
Burning smell
Fixed by
these parts
these parts
Show All
Pumps but will not spin
Fixed by
these parts
these parts
Show All
Too hot
Fixed by
these parts
these parts
Show All
Takes too long to dry
Fixed by
these parts
these parts
Show All
Timer will not advance
Fixed by
these parts
these parts
Show All
Shuts off too soon
Fixed by
these parts
these parts
Show All
Shakes and moves
Fixed by
these parts
these parts
Show All
Spins slowly
Fixed by
these parts
these parts
Show All
Will not stop filling with water
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
No hot or cold water
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
replace broken drive belt
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run belt on,release tension on idler arm.replace front panel and lower top.WALAAH!!!! you are done.
Parts Used:
-
rodney from fairfield bay, AR -
Difficulty Level:Really Easy -
Total Repair Time:15 - 30 mins -
Tools:Screw drivers
271 of 300 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Thermal Limiter opened
Unplugged Dryer.
Opened top of Dryer, over the drum.
Removed Thermal Limiter.
Tested the Thermal Limiter - found it was open.
Checked all vents and exhaust tube for lint build-up.
Replaced Thermal Limiter.
Closed top of dryer.
Plugged Dryer back.
Tested Dryer - it works.
Opened top of Dryer, over the drum.
Removed Thermal Limiter.
Tested the Thermal Limiter - found it was open.
Checked all vents and exhaust tube for lint build-up.
Replaced Thermal Limiter.
Closed top of dryer.
Plugged Dryer back.
Tested Dryer - it works.
Parts Used:
-
Stephen from Newnan, GA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
238 of 311 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
would't spin all water out or rinse out clothes
uplugged washer took front off washer 2 screws pryed up top pump was mounted with 2 screws and 2 wires took off found change in pump and the fins to pump worn off ordered part off line the wait for part was longer than the amount of time to fix problem and cost of part saved me about $25-35 if I was to buy local worth wait save money and fix problem washes like new spins and drains all water from tub.
Parts Used:
-
kenneth from willard, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers, Screw drivers
157 of 193 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
