Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FES375VL1

FES375VL1 Roper Range - Overview

Get Parts and Repair Help for FES375VL1

If you know the range repair part you need, you can browse the list of all parts on the FES375VL1, or you can search by name or part description. You can also find your part by where it is located on the FES375VL1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.



Please note: This is a substitute from the original part. It may physically look different, but will still function the same. This bake element is found on the bottom of the oven.



This oven light assembly is a little over four inches long and comes with the lens and 660-watt light bulb. Make sure your appliance is unplugged or circuit breaker is off before i...


Broil Element

This broil element is found on the roof of the oven and allows for an even heat when cooking food. The element may have shorted out and not be heating the oven, which might indicate it will need to be replaced. Before beginning the repair make sure your oven has been unplugged. Open the oven door and pull the old racks out. You will need to remove the screws holding the old broiler in place at the top of the stove. This is an OEM part that comes right from the manufacturer.


Rocker Switch - Black

This rocker switch can be used for both the oven selector and/or the oven light.


Solid Surface Burner - 8"

Sold individually.




Solid Surface Burner - 6"

Sold individually.


Electronic Relay Board

This board sends information (such as temperature of oven, bake, broil) to the main control board during specific functions.



Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Baking element in the bottom of the stove apparently shorted out and partially melted

  • Customer: Timothy from Salem, OR
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers
  • 49 of 50 people found this instruction helpful
First I turned off the circuit breaker on the house electricity panel. I removed the two screws that held the element in place in the oven. There were two wires connected to the element by spade plugs that were free floating in a fiberglass pad. I reconnected the spade plugs and put the element back in place and put back in the two screws. This procedur... read more

Bake element broke/burned out

  • Customer: edward from hamburg, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 10 people found this instruction helpful
un-screwed 2 scrws and pulled out the old one and pulled off the 2 wires put the new one on the floor of the oven and hooked-up the 2 wires and pushed it in the back wall and replaced the 2 screws! done maybe 5 minutes read more

hard to get old one out

  • Customer: robert from chatham, VA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 28 of 65 people found this instruction helpful
easy to put in read more