FC2002 Rolair Compressor - Overview

Lefoo 4-Port Side Wire Feed. G 1/4" Female (Metric) / 95-125 PSI.

This is an original Rolair replacement part. The wheel is designed by the manufacturer for use in a hand carry compressor. This part is made of high-quality plastic and rubber, and is used to allow the machine to move easily. This product is sold individually. Please keep in mind that the retaining ring used to secure the wheel may no...Read moret be reusable, and may need to be replaced every time it is removed. You may wish to purchase both parts at the same time.

This bleeder valve is a genuine OEM sourced part that is specially designed for use with Rolair air compressors. The bleeder valve allows some air to escape until the air in the tank reaches a certain level. Unfortunately, over time components may wear out or get damaged eventually requiring a replacement. Please note, this high-quality c...Read moreomponent is sold individually. A wrench will be needed to perform this repair. Make sure to drain the air from the tank and unplug the equipment from the power source before starting this repair.

This is an authentic replacement part sourced directly from the manufacturer. The piston assembly is commonly found in Rolair compressors and pumps. This part is made of metal, and includes the piston, piston pin, and two piston pin retainers. You may require pliers and a screwdriver or Allen wrench when replacing these parts.

This is a genuine replacement part which is sourced directly from the original equipment manufacturer for Rolair pumps. The connecting rod is connected to the crankshaft to move the piston within the cylinder. Lack of oil will allow the rings to contact the cylinder, causing scoring, and eventually, seizure of the engine. Dirt in the cyli...Read morender will act like sandpaper, quickly wearing away the piston rings. Using old or stale fuel will cause varnish build-up, which will eventually 'glue' the rings to the piston. Because the rings seal against the cylinder, any of these conditions will often damage the cylinder. As such, whenever you are investigating with a piston ring problem, you should also carefully inspect the cylinder for damage. You may require pliers and a screwdriver or wrench when replacing this item. This high-quality item is made of durable metal and is sold individually.

This is an authentic replacement part manufactured for use with Rolair air compressors. The gauge fits onto the regulator and is used to set the amount of pressure controlled by the regulator. This gauge is threaded and screws onto the regulator, please note the gauge is sold individually.