EX112000 (2005) Campbell Hausfeld Compressor - Overview

This part is an OEM from Campbell Hausfeld. The drain cock-npt 3/8 is compatible with many air compressors, and is sold individually. The metal component allows the operator to drain the condensation out from the compressor tank. Located at the base of the tank, a wrench set is required for the replacement. Please be sure to refer the manual for further safety and repair instructions.

This is a genuine manufacturer sourced replacement part which is specially designed for use with Campbell Hausfeld air compressors. The o-ring provides an air-tight seal between connected parts, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the material may wear...Read more out and begin to crack eventually requiring a replacement, keep in mind this high-quality rubber o-ring is sold individually.

Sourced directly from the manufacturer, this plug is an exact replacement part for a variety of air compressors. This part is sold individually, not as part of a kit or assembly. It is gold, made of metal, and will be found on the pressure switch. This part will leak when it has become defective and will need to be replaced if it is dam...Read moreaged or worn. When you install the part, apply Teflon tape to the threads before tightening it in place. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This is a genuine manufacturer-sourced component which is specially made for use with Campbell Hausfeld air compressors. The purpose of a pressure switch is to control when the compressor should start and stop building up pressure. The default setting of this pressure switch is 135 Psi On and 175 Psi off. Unfortunately, over time componen...Read morets will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality pressure switch is sold individually. Please refer to the appropriate diagrams of your model for the correct location and application of this part.

This is an authentic Campbell Hausfeld replacement part designed to filter out dust and other contaminants on an air compressor. It is sourced directly from original equipment manufacturer and it is sold individually. This filter element consists of a pleated paper in a plastic frame. Replace this air filter element does not require any ...Read moretools. • Remove the filter cover • Remove the old filter element • Secure the new filter in place • Attach the filter cover