Models
>
EW30GC60IS2
EW30GC60IS2 Electrolux Cooktop - Overview
Sections of the EW30GC60IS2
[Viewing 4 of 4]Manuals & Care Guides for EW30GC60IS2
Click to downloadInstall
Installation Instructions
(1.83MB)
Install
Installation Instructions
(6.92MB)
Manual
Owner's Manuals
(2.85MB)
Manual
Owner's Manuals
(16.97MB)
Wiring
Wiring Diagram
(0.12MB)
Keep searches simple, eg. "belt" or "pump".
Igniter/Orifice Mounting Screw
PartSelect #: PS440022
Manufacturer #: 316240600
This part is the igniter/orifice mounting screw for your cooktop or range. It is approximately ½ an inch in length and is made of metal. The mounting screw connects the orifice to the cooktop. If the ...
$12.23
In Stock
SPARK MODULE
PartSelect #: PS11770793
Manufacturer #: 808608804
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
$67.31
In Stock
Burner Knob - Chrome
PartSelect #: PS2582181
Manufacturer #: 318569900
Sold individually.
$104.07
On Order
Questions And Answers for EW30GC60IS2
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the EW30GC60IS2
[Viewing 1 of 1]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Gas stove won’t light on half the appliance
First we replaced the wiring harness because a multi-meter said it wasn’t getting power. That was only partially true. The wiring harness was burned looking so we just kept it instead of sending it back. When the spark module got here the burner caps were removed and then the wires were noted where they went on the module and then the pow
... Read more
er and gas were turned off. The spark module was removed and then the stove was tested and we were back in business.
Read less
Parts Used:
-
Julieta from ELMIRA, NY
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Screw drivers, Socket set
4 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Something broke on the underside of one of the knobs that turn the center gas burner of and on.
I removed the defective knob (which was easy to do, because it was not seated....just sitting on the metal head, but disconnected). I lined up the new knob and pushed down gently.
I turned the knob and the burner lit the way it was supposed to!
I turned the knob and the burner lit the way it was supposed to!
Parts Used:
-
Kirsten from MINNETONKA, MN
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
1 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!