Quick Question!

Have you ever purchased from PartSelect.com before?

Models > EW30EF65GSH

EW30EF65GSH Electrolux Range - Overview

Get Parts and Repair Help for EW30EF65GSH

If you know the range repair part you need, you can browse the list of all parts on the EW30EF65GSH, or you can search by name or part description. You can also find your part by where it is located on the EW30EF65GSH by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for EW30EF65GSH parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EW30EF65GSH

[Viewing 5 of 5]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$28.81

Oven Temperature Sensor

The temperature sensor detects the temperature within the oven cavity. If there is a limited amount of heat, it is not heating evenly, or the oven will not start, this might indica...

Order within the next 11 hrs and your part ships today!
$33.65

PROBE,OVEN TEMP

The temperature sensor measures approximately 9 inches long. It sends the temperature up to the electronic control. Over time this can become weak and might be sending the wrong temperature signal. If you notice that your oven is not producing enough heat, it could be because the sensor has failed. This part is located at the back of the oven, and is held in place by a few screws and a wire harness. These will need to be removed. The sensor can be slid out from the hole. The new one simply slides into place.

Order within the next 11 hrs and your part ships today!
$8.35

Anti-Tip Kit

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, ...

Order within the next 11 hrs and your part ships today!
$5.35

Steel Washer

This steel washer is also known as the range washer and is used on your oven door. The measurements for the steel washer are a three quarter inch outer diameter, and a one quarter inch inner diameter. This washer is an OEM part, made of steel, which is sourced directly from the manufacturer. This specific steel washer is used with your range, to secure the inner and outer door together and to secure the oven door handle back in place. Users have ranked this repair as a simple installation that should take you less than fifteen minutes to complete.

Order within the next 11 hrs and your part ships today!
$9.03

Foot Leveling Leg

Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.

Order within the next 11 hrs and your part ships today!
$92.86

6" Radiant Element with Limiter - 1200W

This is a six-inch radiant element with limiter. It works in conjunction with your stove top range. The purpose of this part is to heat up the cooking area that is located on top of the range, also known as your stove top. If you suspect that your surface element is not properly heating then you may want to test the element for continuity. This model is sold individually and is 1200 watts. The tools you will need for this installation include a Phillips screwdriver and a 14-inch nut driver.

Order within the next 11 hrs and your part ships today!
$6.84

Screw

Sold Individually.

Order within the next 11 hrs and your part ships today!
$123.52

Dual Radiant Surface Element - 9"/6" - 3000W

Order within the next 11 hrs and your part ships today!
$48.09

RACK

Order within the next 11 hrs and your part ships today!
$35.03

TERMINAL BLOCK KIT

Order within the next 11 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Above 400 beeper went off & code numbers came up on read out

  • Customer: Russell from Lake Havasu, AZ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 62 of 71 people found this instruction helpful
Cut off power at fuse panel. pulled stove out from wall went behind stove removed back panels in area of sensor that I could see from the front side, inside oven. Located sensor from rear & unpluged senser from wiring bundle reached inside oven & removed screws from sensor. Pulled sensor out & threaded wire through hole. Took old & new sensors to bench in... read more

Oven wouldn't operated. Error code F9

  • Customer: Richard from Centennial, CO
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 35 of 40 people found this instruction helpful
I called a repair place. They charged $54 to diagnose, (said it needed a new latch motor) then wanted $220 to complete the repair. I checked online prices and did it myself for about 15 minutes work and the latch motor itself ($44?).

Was necessary to uplug the range, pull it away from the wall and remove the back panel sheet metal, then 3 screws ... read more

anti-tip bracket not installed

  • Customer: Brian from Panama City Beach, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 30 of 38 people found this instruction helpful
I was selling my home and did not realize that the anti-tip bracket was not originally installed. A home inspection caught the problem and the buyers required that I install one. I could not find the original and obviously the installer never put it in place to begin with. The buyers wanted this resolved within a week so I had to act fast. I could not fi... read more