EW26SS65GS0 Electrolux Refrigerator - Instructions

I had removed the current cover from the refrigerator by lifting it out of place. I removed the glass insert and placed it in the new crisper cover. I placed the new assembly into position, added the drawer back into the drawer slides, then the refrigerator was back to new!

Removed lower cardboard cover, shut off water supply valve, unpluged frig. Used wrench to remove 3/8 water line from water valve, removed electrical connectors from solenoids, used fingers to unscrew water connections from valve.

Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.

took the back off refridgerator, disconnected water valve assembly, then disconnected water lines and electrcal connectors. also i received the part in less than 24 hours

Punch out center of old support, then pull it out. Insert new suppport, insert center and tap flat with hammer. All done!

Have not really done the repair yet( frig is still to full of Thanksgiving leftovers) but I am sure that with the video that was provided by this site the job will be very simple. Many thanks to the person who put the video together.
John Donnelly

I read other comments and most suggested the fix is less than five minutes and a couple tricks (push the remaining piece into the frig if you can't pull out with pliers)and I did exactly that. Parts came in 2 days, repair took 5 minutes - it took longer to open the package. My wife thinks I'm a star!

Simple, I had a repair man come over and diagnose the problem. After confirming, I ordered the part and replaced it. Need to make sure you get the ice build up out of the fitting tnat goes from the back of the fridge connection at the top and the filler tube inside the unit, mine was iced over. Repair man wanted to charge me $250.00... with his service call and buying the part, it cost $120

I pull out the broken part by push the center pin thru and then rerome all the parts. I then positioned the new part in place and push in the center pin to lock. quick and easy.

Water was leaking so I replaced the entire valve and just followed the color codes and thats it. Plug and play.

took existing water valve loose, removed plastic water lines and reinstalled on new valve and installed new valve into refrigerator

This is an easy repair. Unplug appliance. Remove the old water valve by unscrewing it from the frame of the refrigerator. Disconnect the cables and all the water hoses. The hose fittings are a different type: clip off the old connectors from the hose ends and push the hoses straight into the new connectors till they fit solidly. Reconnect the cables and screw the valve back onto the frame of the refrigerator.
Unfortunately, my leak was from a hose, not the valve, so this didn't actually fix it.

Drove pins all the way thru supports & then pryed support off. Tapped new supports in place. Watch the vidio on installing new supports. I probably wouldn't have been able to get the supports off without the trick I learned to just knock them on thru. Took all of 5 minutes to replace 4 supports.

Watched the video and read some comments and from that it was easy

Very easy repair, instruction were clear and easy to follow