All Installation Instructions for General Electric Refrigerator ETS22XBPCRCC

Would not self defrost.

Remove the shelves then remove the back by removing the two screws at the top of the panel. Locate the temperature sensor on top of the coil. Cut the wires and replace with the new one. Use wire nuts and electrical tape to reconnect the wires.

Parts Used:

Temperature Sensor

Greg from Rockwood, TN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

refriger warm

replace sensor in refriger.

Parts Used:

Temperature Sensor

chol from Glenview, IL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Food section of fridge always warm

Located temperature sensor on condenser in the freezer section( as per instructional video ). Cut off bad sensor with wire cutter then soldered on the new sensor and sealed with electrical shrink wrap.

Parts Used:

Temperature Sensor

Troy from Dacula, GA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set

Was this instruction helpful to you?

freezer no cold enought

as per video- follow all of the videos and u r going to save a lot of money tx partselect im glad I found u guys ps only order from partselect.com they only ship the correct parts remember look at the video select the symptom and buy as per video tx again problemsolved

Parts Used:

Temperature Sensor

John J. from Deland, FL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

refig light did not work

per your instructions

Parts Used:

LIGHT SWITCH

paul from east hanover, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

coil frosting up and refridgerator section was not cooling

took out shelves and removed the back plate my removing 2 screws with a nutdriver.removed the old defrost timer and defrost heater which was really easy.then installed the new ones.the video i watched on the website was really helpfull.

Parts Used:

Temperature Sensor

Vernon from Harmony, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

frige too cold

changed sensors did not repair problem,replaced damper with mechanical damper fixed problem.

Parts Used:

Temperature Sensor

John from Island Lake, IL
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

extreme frost build up inside in back of freezer,also veggies were freezing in the fridge draw

no brainer,watched the video,worst thing was to thaw the freezer,it was realy frosted,works like new,very happy thank you.

Parts Used:

Temperature Sensor

larry from lisbon, ME
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

failed light switch

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Parts Used:

LIGHT SWITCH

Jules from Crowley, LA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

refrige ws too cold

as per video

Parts Used:

Temperature Sensor

Jeffrey from Saint Charles, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

missing handle

snap in part. Lined up; snapped in!

Parts Used:

HANDLE PAN DELI

Albert from Laurel, MD
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

no light in freezer

Connected the 2 wires and pushed in the switch until it clicked.

Parts Used:

LIGHT SWITCH

christopher from collegeville, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

switch wouldn't come out anymore and turn light on

Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy

Parts Used:

LIGHT SWITCH