ERV36-ER Dacor Range Hood - Overview

Diagrams for ERV36-ER

See every part. Know exactly what you need.

DACOR Vent system Vent system Parts

Parts for the ERV36-ER

Svc Harness Switch

Part #DE81-09306A

$343.95

Drive Motor Switch

Part #DE81-04650A

Motorized downdraft vents depend on a working drive motor and switch for smooth movement. Slow travel, grinding sounds, or failure to stop in the correct position may signal a problem with this assembly. Check for grease buildup, debris, bent lift parts, and damaged wires before ordering a replacement. Match the part to the full appliance...Read more

Read less

$138.39

Filter Grille

Part #DE81-08655A

$21.95

Service Slim Line Knob

Part #DE81-09307A

$6.55

Clip

Part #DE81-10408A

$98.84

Fan Speed Control Kit

Part #DE81-05286A

$61.54

SVC Pot Harness Kit

Part #DE81-04013A

$233.95

Drive Arm

Part #DE81-10298A

$6.40

SVC-SCREW;83408,#8-32X 3/4 PHIL,DR30D-C/

Part #DE81-02063A

SVC-COUNTER SEAL 33 50;62233,E36DD75ESS

Part #DE81-07747A

$27.76

Slim Line Bezel

Part #DE81-09034A

$41.40

SVC-SUPPORT LEG LEFT;36861,E30DD75ESS

Part #DE81-08666A

Questions And Answers for ERV36-ER

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:

Leroy - For model number ERV36-ER

August 23, 2022

Dacor model ERV36-ER raises and lowers constantly when turned on. At the top of travel a relay turns on to start the vent motor but then cuts out immediately then the assembly lowers. When completely lowered the cycle starts again. We also notice a slight jerk at the very top and bottom of travel.

Hello Leroy, Thank you for the question. This is normally an indication the Limit Switch in the drive motor switch is faulty. Disconnect electrical power to the downdraft vent and test continuity through the limit switches using a multimeter. Replace a limit switch if you measure the same continuity through a limit switch when the switch is activated and deactivated. If the Limit Switch is faulty, the Drive Motor Switch will need to be replaced. We hope this helps, good luck with this repair!

$343.95

Drive Motor Switch

Was this helpful?

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

I bought the wrong unit

2 of 2 people found this instruction helpful.

Donald from Metairie, LA
A Bit Difficult
1- 2 hours
Pliers, Screw drivers

The downdraft vent I wanted would rise up 10". The one I ordered went up 15". Looked like the Great Wall of China on our countertop. Dacor tipped me off on the change out of the drive arm and raise arm to make it rise less. The raise arm still proved to be about 3.5" too long so I had to drill a new hole in it and lop off that much ste ... Read more

Read less

Other Parts Used:

Drive Arm

Slim Raise Arm

Was this helpful?