EM400A Honda Generator - Overview

This item is an authentic OEM part which is made for use with Honda engines commonly installed on a variety of lawn and garden equipment. The clip is utilized to secure the fuel tube. If the clip is damaged or is missing, this will provide an identical replacement for a missing or a damaged component that was installed on a new unit. Chec...Read morek the diagrams of your model for the exact location and the correct application of this hardware. One durable metal clip is included. You may need pliers to secure and remove it.

A ball bearing is a type of rolling part that consists of an inner and outer-ring, and a set of steel balls fit between them that allow rotational movement with reduced amounts of friction. This ball bearing is designed for use within the crankcase of various models of small engine equipment such as generator, tiller and lawn mower/tracto...Read morer, and is used to support the crankshaft so it can rotate smoothly and withstand the various mechanical pressures sounding it. This bearing is sold as an individual OEM part and features a 0.68-inch (17mm) inner-diameter, 1.38-inch (35mm) outer-diameter and .47-inch (12mm) width. If you notice any sort of excessive vibrations, noise, wobbling, or significantly reduced engine performance, the ball bearing is likely worn out or damaged, and in need of replacing, but it is best to inspect the crankcase area for any other possible issues. To replace this bearing, you will need a screwdriver and socket wrench to gain access to the inner portion of your engine, where the crankcase is located. Disconnect the spark plug and follow the user manual and the official disassembly procedure according to the manufacturer, which normally involves removing the engine cover, carburetor and ignition coil. With access to the bearing, carefully remove it before cleaning and properly lubricating the area. Install the new bearing and make sure it and the crankshaft are properly aligned before you reassemble the rest of the motor.

Hex nuts are used within small engine equipment for a variety of reasons, such as fastening bolts, screws, or studs, and in general assembly to join two parts together. This hex nut is made of durable metal and is sold as an individual OEM part for use within small engine equipment such as snow blowers, generators, tillers, trimmers, and ...Read morelawn tractors. This hex nut serves a variety of purposes, depending on the location and piece of equipment it is installed within. This hex nut measures 6mm in inner diameter and will require a hex socket wrench to install and replace.