This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.
This is the mechanics (motor/engine) of the cooling system. It kicks in whenever the thermostat demands cooling.
This kit includes the compressor, relay, overload, drier filter, 4 pieces of tubing and mounting grommets.
***NOTE: This part needs to be installed by a trained professional in appliance repair. It requires special tools and knowledge to do so.
This basket provides organized storage and easy access during appliance operation. Sturdy construction supports regular use without sagging or shifting. Replacing a damaged basket restores capacity, stability, and convenience.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Compressor "grounded" and quit running
59 of 118 peoplefound this instruction helpful.
Mike from Baytown, TX
Easy
1- 2 hours
Nutdriver, Pliers, Wrench (Adjustable)
Replaced the compressor with the new one I purchased from you. Installed new parts and recharged unit. The refrigerator / freezer is working better than new. Thanks for the great deal on the compressor. It was here in 3 days. All the parts fit exactly and had no difficulty in the installation or startup. The directions for the wirin
... Read moreg were a great help also. Thanks again.
Read less
Was this helpful?
Thank you for voting!
light switch metal was corroaded by the moisture. there was no contact so light wouldnot turn on.
7 of 10 peoplefound this instruction helpful.
Henry from Monrovia, CA
Easy
Less than 15 mins
Pliers
pulled switch from door ,unpluged it and then plued in new switch.
Was this helpful?
Thank you for voting!
Overload was open
4 of 8 peoplefound this instruction helpful.
richard from galena, KS
A Bit Difficult
30 - 60 mins
Screw drivers
New part was similar, except contact blade was for a full 1/4", my model utilizes 1/8". So I cut the blade in half with a hacksaw, filed off the rough edges and reassemblied the connector; attached it to the compressor Now being a retired electronic engineer; who's great idea was it to hide a klixon inside the connector?