This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
This screw is sold individually. It is a genuine OEM replacement part, and it is designed for use with refrigerators. Most often it is used with the ice bucket ice deflector, retainer clip, and front cover. Due to varied uses we recommend referring to model-specific diagrams for exact placement. This screw measures 8-18 by 1/2 inch.
This basket provides organized storage and easy access during appliance operation. Sturdy construction supports regular use without sagging or shifting. Replacing a damaged basket restores capacity, stability, and convenience.
Keep cold air contained with a replacement freezer door or lid gasket. A damaged seal can allow moisture inside, leading to frost, temperature changes, and longer cooling cycles. First, clean the existing gasket and cabinet edge, then check for gaps or hardened sections. Make sure the lid is aligned correctly because loose hinges can also...Read more prevent a proper seal. Verify compatibility using the full appliance model before purchase. Disconnect electrical power before replacement. If the new gasket arrives folded, soften it with warm water or gentle heat. Avoid overheating the material. Install it evenly, close the lid, and inspect the entire seal for gaps.
This part maintains the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Overload was open
4 of 8 peoplefound this instruction helpful.
richard from galena, KS
A Bit Difficult
30 - 60 mins
Screw drivers
New part was similar, except contact blade was for a full 1/4", my model utilizes 1/8". So I cut the blade in half with a hacksaw, filed off the rough edges and reassemblied the connector; attached it to the compressor Now being a retired electronic engineer; who's great idea was it to hide a klixon inside the connector?