EH092F10041 (EH092) Subaru Engine - Overview

This gasket, also known as the oil drain plug gasket, is a ring-shaped, metal component used in outdoor power engines. It is supplied by the manufacturer and can be found at the bottom of the engine oil pan where the drain plug is installed. The gasket is responsible for sealing the area between the oil drain plug and the engine block to ...Read moreprevent oil from leaking during oil changes. Over time the gasket can wear down, corrode, or crack. If the gasket can no longer seal the area, oil will escape from the oil pan, leading to inadequate lubrication, increased friction, and engine damage. Before you begin the repair, drain the oil from the engine to prevent contamination. Use a wrench to loosen and remove the oil drain plug. Peel off the old gasket, and thoroughly clean the drain plug and oil pan surface. Install the new gasket and ensure that it sits firmly on the oil pan. Finally, reinstall the drain plug, and be careful to avoid overtightening it.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Subaru engines. The fuel cap seals the fuel tank to ensure it stays contained as well as keep debris from getting into the tank. The fuel cap is made of plastic and is sold individually. No tools are required for installation, simply screw on the fuel cap firmly to the fuel tank to secure.

This replacement part is supplied from original equipment manufacturer made for use with Subaru/Robin engines. It is commonly used to secure muffler cover. This tapping bolt has a head meaning to install or remove it you could use either a wrench or a torx screwdriver. Includes one (1) bolt per order.