E900A Honda Generator - Overview

This metal washer is compatible with several different makes and types of small engine equipment, and is a genuine OEM part. Used to evenly distribute pressure on the oil drain from the drain bolt, this washer has a 19mm/.75-inch outer-diameter and 12mm/.5-inch inner-diameter and is sold individually without the drain bolt, which is sold ...Read moreseparately. It is, however, recommended that if you replace this washer, you replace the drain bolt as well.

This item is an original part from Honda for use in engines and lawn mowers. The circlip attaches to the gear. You may need a set of pliers when replacing this item. Over time this part may break and will need to be replaced. It is made of metal and is sold individually.

This is a genuine manufacturer-approved component which is specially made for use with Honda engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or a faulty nut that helps to secure the tappet adjusting screw. Please make sure to refer to the appropriate diagrams of your model for the corr...Read moreect location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This item is an authentic OEM part which is made for use with Honda engines commonly installed on a variety of lawn and garden equipment. The clip is utilized to secure the fuel tube. If the clip is damaged or is missing, this will provide an identical replacement for a missing or a damaged component that was installed on a new unit. Chec...Read morek the diagrams of your model for the exact location and the correct application of this hardware. One durable metal clip is included. You may need pliers to secure and remove it.

This is an original replacement part manufactured for use with Honda small engines. The starter rope is pulled to engage the flywheel to start the engine, and the rope recoils back into the starter when the rope is released. The starter rope is sold individually, please see model diagram for associative parts.

A ball bearing is a type of rolling part that consists of an inner and outer-ring, and a set of steel balls fit between them that allow rotational movement with reduced amounts of friction. This ball bearing is designed for use within the crankcase of various models of small engine equipment such as generator, tiller and lawn mower/tracto...Read morer, and is used to support the crankshaft so it can rotate smoothly and withstand the various mechanical pressures sounding it. This bearing is sold as an individual OEM part and features a 0.68-inch (17mm) inner-diameter, 1.38-inch (35mm) outer-diameter and .47-inch (12mm) width. If you notice any sort of excessive vibrations, noise, wobbling, or significantly reduced engine performance, the ball bearing is likely worn out or damaged, and in need of replacing, but it is best to inspect the crankcase area for any other possible issues. To replace this bearing, you will need a screwdriver and socket wrench to gain access to the inner portion of your engine, where the crankcase is located. Disconnect the spark plug and follow the user manual and the official disassembly procedure according to the manufacturer, which normally involves removing the engine cover, carburetor and ignition coil. With access to the bearing, carefully remove it before cleaning and properly lubricating the area. Install the new bearing and make sure it and the crankshaft are properly aligned before you reassemble the rest of the motor.

Hex nuts are used within small engine equipment for a variety of reasons, such as fastening bolts, screws, or studs, and in general assembly to join two parts together. This hex nut is made of durable metal and is sold as an individual OEM part for use within small engine equipment such as snow blowers, generators, tillers, trimmers, and ...Read morelawn tractors. This hex nut serves a variety of purposes, depending on the location and piece of equipment it is installed within. This hex nut measures 6mm in inner diameter and will require a hex socket wrench to install and replace.