E30GC74GPS1 Electrolux Cooktop - Overview
Sections of the E30GC74GPS1
[Viewing 4 of 4]
Keep searches simple, eg. "belt" or "pump".
Burner Mounting Screw
PartSelect #: PS2361437
Manufacturer #: 316540900
Sold individually.
$25.25
In Stock
Control Knob - Stainless Steel
PartSelect #: PS2353127
Manufacturer #: 318242252
Sold individually. This knob accepts a D-shaped shaft.
No Longer Available
Burner Control Knob - Stainless Steel
PartSelect #: PS1992172
Manufacturer #: 318242226
Sold individually. This knob accepts a D-shaped shaft.
No Longer Available
Manuals & Care Guides for E30GC74GPS1
Click to downloadInstall
Installation Instructions
(2.8MB)
Manual
Owner's Manuals
(13.34MB)
Manual
Owner's Manuals
(4.69MB)
Wiring
Wiring Diagram
(0.09MB)
Common Symptoms of the E30GC74GPS1
[Viewing 2 of 2]Will Not Start
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Top burners were not lighting without a match
Was easy...I pulled oven out from the wall so I could get to the back.i used a nut driver to remove small silver cover.matched up wires to the never module and re installed.pluged oven back in and burners lit perfectly
Parts Used:
-
Earl from ALLIANCE, OH
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Pliers
3 of 4 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
burner ingnighter would not lite burner
Replaced the ingintion module, still did not work, replaced the burner complete with new ingiter , it now works but another one quit . the front right one has 5 ohms resistance ,replaced with new one with 0 ohms, the back left has 2 ohms resistance and now it does not work , will need to replace that burner allso. too bad you can't buy ju
... Read more
st the spark module for the burner.
Read less
Parts Used:
-
Wayne from Palestine, IL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
30 of 86 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Two of theTop gas burners would not spark
Took 6 screws out holding the top on from the sides. Lifted the top front, popped out the spark module, Took 6wires off & reversed the processed to install the new one. I was really amazed when I ordered it Wednesday and it arrived on Friday. Believe me I bookmarked this site.
Parts Used:
-
Robert R from Lewistown, PA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!