DWS779 (Type 20) DeWALT Saw - Overview

This is a genuine Dewalt replacement part, it is sold individually. The purpose of the Blade Adapter, is to make the bore of a blade that is 1 inch and reduce to a 5/8 inch bore. Making it possible to use a 1 inch bore blade on a 5/8 inch arbor.

This is a genuine manufacturer sourced replacement part designed for use with Dewalt miter saws. This wear plate helps to minimize the friction and avoid potential wear to the table assembly. It is made out of plastic and it is sold individually.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 10 Feet Long

This replacement screw is a high quality hardware commonly utilized on Bostitch, Black and Decker, Porter Cable and Dewalt equipment. This is a authentic OEM item which has multiple applications depending on the unit, for correct location and use of this screw make sure to check appropriate diagrams. Please note this torx screw is sold individually.

This Ball Bearing is sealed on both sides. It is a genuine replacement part and is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the too...Read morel and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

Restore the cutting performance of your miter saw with this motor assembly, the component responsible for powering the blade and delivering the performance needed for accurate, efficient cutting. Replacing a worn, damaged, or failed motor can help restore power, reliability, and overall tool functionality. This assembly is designed as a d...Read moreirect replacement and may include the drive pulley already installed for easier servicing. Because wiring and mounting configurations can vary between models, refer to your tool's parts diagram or service manual to confirm the correct application and installation before repair. Sold as a complete assembly.

This is a genuine manufacturer-approved replacement part which is specially designed for DeWALT saws. Bushings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the bushing is damaged or is missing, this will provide an identical replacement for the original ha...Read morerdware that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the proper repair procedure. Note, this high-quality part is sold individually.

Genuine Dewalt replacement part, this item is sold individually. The purpose of the 394589-01 Screw is used to secure the pivot plate on the Miter Saws listed below. You can use a flat blade screwdriver or a Torx T-30 bit on this screw.

This is a genuine manufacturer approved replacement part designed for use with Dewalt miter saws. This bushing helps to secure the blade to the shaft/spindle. It is made out of metal and it is sold individually. To replace it you would need a wrench to remove the blade bolt.

Included in part number 606883-00

This needle bearing is open on one side and closed on the other. This genuine DeWalt replacement part is sold individually. • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. ...Read moreThis reduces wear on the tool, allowing it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.