DWE7480 (Type 20) DeWALT Table Saw - Overview

Genuine DeWalt replacement part Includes 1 Carbon Brush with wire lead and brush spring attached.rn • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced pow...Read moreer tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This replacement hand wheel is sourced directly from original equipment manufacturer. It is a genuine part designed for use with Dewalt table saws. This is the hand wheel that allows you to adjust the blade height. It is made out of metal with a plastic knob. Please note the bevel handle is sold separately. To complete this repair you wo...Read moreuld need a socket wrench. • Remove the handle bolt • Remove old hand wheel • Secure the new assembly with a bolt

This is a genuine OEM approved replacement part made for Dewalt table saws. This wing knob is used to secure the dust cover to the unit. Please refer to diagrams for correct use. It is made out of metal and it is sold individually. Includes a metal washer.

This replacement foot is a high quality item that is specially designed for Dewalt table saws. It is secured to the roll cage helping to support the unit. This item consists of a durable rubber pad with a metal threaded shaft and it is sold individually. Please note the flat washer and the nut that secure this foot are all sold separately.

This replacement screw is a genuine Dewalt part. It is sourced directly from original equipment manufacturer for use with table saws. Two of these screws are used to secure the switch plate. This is a Phillips head screw that is sold individually.

This lock nut is sourced directly from an original manufacturer. It is designed for use with Dewalt table saws. This is standard hardware which has multiple applications based on your tool. Please refer to diagrams for proper application. It is made out of metal and it is sold individually. You would need a wrench to remove or install this nut.

This authentic component is an OEM part which is designed for use with DeWALT table saws. It helps to secure the bevel gear to the shaft. This is an identical replacement for a damaged or a faulty hardware that was installed on a new unit. Keep in mind this high-quality ring is made of durable metal and is sold individually. Make sure to ...Read morecheck the appropriate diagrams of your model for the exact location and the correct installation of this component. It is best to use snap-ring pliers to secure and remove it.

This is a genuine DeWALT replacement part for use in table saws. The elevating screw fits between the key and the flat washer. A screwdriver may be needed during the replacement of this part. This part is made out of metal and will need to be replaced if it breaks. This item is sold individually.

This locating pin is an OEM part from DeWALT. It is used on table saws to prevent the rail from sliding too far. It will require a properly sized wrench to install. The threads may strip or the pin may get lost, so this authentic part will provide an identical replacement of the original pin. Multiple metal pins are used, but this is an i...Read morendividual part priced as one item. Note, a nut is required to secure this pin to the rail which is not included and is sold separately. Please refer to the correct diagram of your specific model to install the pin properly.

This is a genuine manufacturer approved replacement part designed for use with Dewalt table saws. It allows you to adjust and align your table saw. It is made out of metal and it is sold individually. You would need a wrench to replace this lever. • Remove the nut that secures lever to the shaft • Replace the old lever with a new one • Secure lever to the shaft with a nut