DWE4887N (2) DeWALT Grinder - Overview

Genuine Dewalt replacement part This brush is sold individually, 2 are needed for the tools shown below It is always best to replace both brushes, even if only one is worn. Worn brushes frequently are the cause behind a motor running poorly. Replacing brushes can fix a motor that's operating intermittently. New brushes can restore a ...Read moremotor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

Keep your die grinder operating safely and efficiently with this replacement wrench, designed for tightening and loosening the collet nut during accessory changes. Its slim profile allows easy access to the spindle and collet assembly, making it simple to install or remove burrs, grinding stones, sanding drums, and other attachments. Cons...Read moretructed from durable steel for long-lasting use, this wrench is an ideal replacement for a lost, damaged, or worn original tool. Because accessory retention systems can vary between models, refer to your tool's owner's manual or parts diagram to confirm the correct application before use. Sold individually.

This plastic switch is supplied by the original manufacturer. It is used in DeWALT small angle grinders. This is a push-button switch controlling on-off functions. One (1) switch is included. Please note that linkage and button slider are sold separately. • Disassemble housing • Remove wiring from the old switch • Disconnect switch from linkage • Reconnect new switch and reassemble housing