DWE304 (2) DeWALT Reciprocating Saw - Overview

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This connecting ball is an authentic manufacturer replacement part used in various power tools. It is a stainless-steel ball that provides a pivot point that allows the attached components to move back and forth smoothly during use. If the connecting ball falls off or becomes loose, worn out, or damaged, the equipment will become unstable or unable to move at all.

Genuine Manufacturer Sourced replacement part. This item is made out of Carbon with a Lead Wire attached. This item includes One (1) Carbon Brush per order. It is recommended to replace both Carbon Brushes when replacing one. Please note Brush Holder and Spring are Sold Separately. Carbon motor brushes are one of the most commonly replac...Read moreed power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This is an authentic part assembled by the original manufacturer. It is compatible with Black & Decker, Porter Cable, and DeWALT saws and other handheld power tools. A bearing acts as a buffer between moving parts. This reduces friction between those parts. Bearings also stabilize and hold metal parts, preventing damage from incorrect dir...Read moreectional movement. These are highly worn parts and require replacement fairly often when in regular use. This bearing is sold individually. Please note that on most of these tools, there are two different needle bearings used. This is the topmost bearing, located closer to the gear cover plate. The other is sold separately.

This synthetic gear grease is used to lubricate internal gears in power tools, reducing friction, wear, and noise during operation. Its high-performance formula helps prevent corrosion and protects moving parts under load. Applying fresh grease during maintenance restores smooth gear movement and extends tool life.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.