DW997K-B3 (5) DeWALT Boring Machine - Overview

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This screw is a genuine Dewalt chuck screw. It is constructed of tough steel for long life. It has a beveled head with torx drive for a secure fit. This screw is reverse thread for securing drill chucks. It also has locking compound within the threads for an even tighter installation. This screw is commonly found in Dewalt cordless...Read more drills and it is compatible with the tools listed below. It is not guaranteed to fit any other power tools.

This item is a genuine DeWalt replacement part that is intended to be used with cordless drills and drivers. The bit clip can be used as a direct replacement of the original clip that would have been installed on a new drill. The clip snaps onto the side of drill's housing and is used to store frequently used drill bits. This item is priced as a single replacement part.

Included in part number 385475-00

Included in part number 385475-00

Included in part number 385475-00

Included in part number 385475-00

Included in part number 385475-00

This is an authentic DeWALT replacement part. The spring is commonly found in DeWALT power tools such as drills and screwdrivers. This is a metal part used to hold the shifter switch in place. This part is sold individually.

This brush kit is supplied directly from original equipment manufacturer. It is a genuine replacement item that is specially designed for use with drills/drivers. Carbon brushes are some of the most commonly replaced items. Due to normal use and friction brushes will gradually wear down requiring replacement. It is advised to replace both...Read more brushes at the same type. This set includes two (2) carbon brushes, two (2) metal brush holders with springs and two (2) lead wires. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the housing screws • Separate the housing halves • Disconnect lead wires • Take out old brushes and replace them with the new ones • Reassemble and test the tool