DW887N (Type 4) DeWALT Angle Grinder - Overview

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

The paddle attaches to the lock button and is made of plastic. It is a genuine DeWALT replacement part for use in grinders. This item is available as an individual replacement part. If this part becomes broken it will need to be replaced and may require a set of pliers during the installation.

This genuine manufacturer-approved replacement switch is specially produced for use with Hitachi compound miter saws. It is the part of the tool handling on/off operations. Over time due to regular use the switch may develop mechanical or electrical issues eventually requiring replacement to maintain a working tool. It is a high-quality c...Read moreomponent which is made of durable plastic with metal and it is sold individually.

This is an authentic replacement part manufactured for use with DeWalt power tools. The ID Label is a sticker of the DeWalt logo and is often needed when the tools housing is replaced. This logo is sold as an individual replacement part, please see model diagram for associative parts.