DW828 (Type 1) DeWALT Chop Saw - Overview

This is an Original Manufacturer Sourced replacement Side Handle used on certain Angle Grinders. This part consists of a Metal Shaft, Plastic Body and Rubber Grip. Angle grinders are equipped with a side handle, which helps you to better control the tool while it is in operation, especially when performing heavy grinding or cutting. To replace simply screw in the new handle into the slot in the body of the tool.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This wrench is an OEM direct from Craftsman for angle grinders. This part helps the motor shaft stay in place when the user pulls out or replaces the grinder disc. It is recommended to review your models diagram to verify the parts compatibility. This part is made of metal and sold individually.

This is an authentic Dewalt carbon brush, not an aftermarket imitation. It is specially designed for use with angle grinders. Its function is to conduct electric current in power tools. This item includes (1) carbon brush with a lead wire attached. Please note, the brush box assembly is sold separately. It is advised to replace both brush...Read morees at the same type. You will need a screwdriver to replace this brush. • Make sure the unit is unplugged • Remove the housing • Take out the old brush • Secure the new brush • Reassemble and test the unit

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

The paddle attaches to the lock button and is made of plastic. It is a genuine DeWALT replacement part for use in grinders. This item is available as an individual replacement part. If this part becomes broken it will need to be replaced and may require a set of pliers during the installation.

This is an authentic OEM sourced item, it is not an aftermarket alternative. It is specially produced for a Dewalt cut-off tool. Its purpose is to secure the disk to the spindle. One durable metal clamp nut is included per order. Please note, the backing flange is sold separately. You will need a spanner wrench to install or remove this clamp nut.