DW735 (Type 1) DeWALT Planer Jointer - Overview

Genuine Dewalt replacement part, this item is sold individually. This is a Drive Sprocket that works in conjunction with a drive chain. It is used on the Dewalt Planers shown below to drive the feed rollers. Depending on the model number you have, as in case of the DW734 uses one. The DW735 and the DW735X use four of this part.

A genuine item which is supplied directly from the original equipment manufacturer for use with DeWALT planers. It is a special felt seal for the main roller, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of du...Read morerable material and is sold individually. Over time it may wear out and begin to crack eventually requiring a replacement.

The metal spring connects to the idler shaft and is a genuine item that is supplied directly from the original manufacturer for use with planers made by DeWALT. This part is priced as an individual replacement part. It may become broken and will need to be replaced. A set of pliers and a wrench may be necessary during the replacement of this spring.

This is a genuine Dewalt replacement part, it is sold individually. The purpose of this screw is to secure the planer knives to the cutterhead on the planers shown below. It is also used on the DW7351 Folding Table. It is a allen head screw. A complete set of 24 screws including the wrench can be ordered by using part number 5140067-11, the screws in the set are Torx heads.

This is a genuine OEM sourced replacement screw which is specially designed for use with DeWALT planers. It is a standard hardware which has multiple applications, please refer to the appropriate diagrams of your model for the correct location and use of this screw. This part is made of high-quality metal and is sold individually.

This circuit breaker is specially produced for Dewalt planers. It is a genuine OEM sourced replacement part, not an aftermarket equivalent. Your planer is equipped with an 18 amp circuit breaker. If your planer becomes overloaded and stops operating, turn off the planer and press the reset button. If you have a faulty circuit breaker the ...Read moremotor would not start. Please note, this item is sold individually. To complete this repair you should only need a screwdriver.

This is a genuine DeWalt part that is OEM sourced to ensure a high level of quality. The rear roller is intended to be used with 13" planers. This item attaches to the drive chain and sprocket and is used to guide material out of the back of the planer. This item is available as an individual replacement part.

Genuine Manufacturer Approved replacement part designed for certain DeWALT Planers. This part is made out of Plastic and it is Sold Individually. This Adapter allows you to connect Dust Chute to your unit.

This replacement dust shroud is an authentic OEM part which is designed for use with DeWALT planers. Fan-assisted chip ejection vacuums chip off of the cutter head and exhaust them out of the machine. This part helps to direct dust and trimmings away from a user. Always wear eye protection and a dust mask if necessary. Note, this high-qua...Read morelity dust shroud which is made of a durable plastic material and is sold individually. Check the owners manual and the diagrams of your specific model for the correct installation and application. The shroud is secured by three thumb screws which are sold separately. No tools would be needed to replace this part.

This drive belt is for planers. Drive belt connects the motor pulley to the spindle assembly to spin the blades. Disconnect the power cord before installing this part. Wear work gloves to protect your hands.

This item is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with planers. The cap is used to cover the end of the post assemblies. The cap is sold as an individual piece, please note four caps may be required.