DW717-AR (1) DeWALT Miter Saw - Overview

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

This is a genuine manufacturer-approved replacement part which is specially designed for DeWALT saws. Bushings are generally utilized to provide a tight fit between connected components while allowing for movement with minimum friction. If the bushing is damaged or is missing, this will provide an identical replacement for the original ha...Read morerdware that was installed on a new unit. Refer to the appropriate diagrams for your model to ensure the proper repair procedure. Note, this high-quality part is sold individually.

Genuine Dewalt replacement part, this item is sold individually. The purpose of the 394589-01 Screw is used to secure the pivot plate on the Miter Saws listed below. You can use a flat blade screwdriver or a Torx T-30 bit on this screw.

This is a genuine manufacturer approved replacement part designed for use with Dewalt miter saws. This bushing helps to secure the blade to the shaft/spindle. It is made out of metal and it is sold individually. To replace it you would need a wrench to remove the blade bolt.

This is an Original Manufacturer Approved replacement part used on some Compound Miter Saws. This part is made out of Metal and it is Sold Individually. The purpose of this Clamp is to help securing a Blade to the unit.

This genuine manufacturer approved bearing is used to secure spindle and gear that drive the saw blade. It is designed to minimize the friction, over time bearing will begin to fail compromising units functionality. At this point replacing ball bearing should restore unit back to functional condition. This is a sealed metal bearing that is sold individually.

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used with miter saws. The metal pulley key is used to link a rotating shaft and a pulley to allow the two parts to rotate in unison. This pulley key is priced as a single item.

This flanged sleeve, also known as a bushing or sleeve bearing, is responsible for securely connecting the guard link assembly to the upper guard assembly in your miter saw. It maintains stability and proper alignment between these two components. The guard link is the part that attaches to the blade guard and is responsible for lifting t...Read morehe guard when the saw blade is lowered. If you notice that the flanged sleeve is worn, damaged, or has excessive play, it can cause the guard link to become wobbly, restrict its movement, or produce unusual noises during operation. To replace the flanged sleeve, you will need a screwdriver with a Torx bit. Simply unscrew the screws on each end of the guard link to remove it along with the flanged sleeves. It is important to note that this replacement part is an authentic OEM component and is sold individually.

This is a genuine OEM sourced replacement part designed for use with DeWALT compound miter saws. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this durable metal screw is sold individually.

This is a genuine Dewalt replacement part, it is sold individually. The purpose of this bolt is to secure the blade on the miter saw models shown below. It has a 1/2 " hex head. It is 1 inch long, with left hand threads.