DW703 (Type 1) DeWALT Miter Saw - Overview

Sold Individually. This carbon brush fits a variety of gardening and lawn tools. The brush is a common replacement part and can easily fix most motor malfunctions. This brush comes with a wire lead and a connection terminal. Inspect the wire lead for any damage and replace immediately if burns or cracks are noticed. Refer to the diagram provided by the manufacturer for installation instructions.

This M8 × 1.25 elastic stop nut (lock nut) is an OEM replacement fastener used on power tools to securely hold critical components in place while resisting loosening from vibration. Designed with an integrated nylon insert, it provides reliable locking force without the need for additional hardware and is ideal for replacing worn or missing nuts during maintenance or repair to ensure safe, stable operation.

This replacement screw is a genuine OEM sourced hardware that is specially designed for with Delta, Dewalt and Black and Decker power tools. This screw is a standard hardware which has multiple uses based on equipment, to ensure correct application of this item please make sure to check appropriate diagrams of your unit. One durable torx screw is included per order.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 10 Feet Long

This Kerf plate is a genuine DeWalt replacement part. It is made of plastic with a slot in the middle for the saw blade to slide through. It has 3 screw holes on each side (6 in total) to firmly secure the kerf plate to your saw. rnrnKerf plates (also called kerf boards) are used to prevent excessive splintering, resulting in cleaner c...Read moreuts. Using the wrong kerf plate for your tool can give a rough edge to the material you’re cutting.

Genuine Dewalt replacement part, this item is sold individually. The purpose of the 394589-01 Screw is used to secure the pivot plate on the Miter Saws listed below. You can use a flat blade screwdriver or a Torx T-30 bit on this screw.

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This OEM Universal dust bag fits all of the DEWALT miter saws. It comes with the adapter which is not sold separately. Please note some DW718 Models may require an adapter part #618240-00 to make it work. The purpose of the dust bag is to capture sawdust to keep your shop and your work surface cleaner.

This is an original manufacturer sourced replacement part designed for use with Dewalt compound miter saws. It allows you to lift and lower the saw. This item is made out of plastic and it is sold individually. Includes both sides of the handle. Please note the screws used to attach it and the carrying handle are sold separately. You wou...Read moreld need a screwdriver for this repair • First you would remove the screws from carrying handle and remove it • Then, remove the screws in the top handle half and remove it • Remove the switch from the bottom half of the handle • Remove the cord clamp that is held in by two (2) screws. • Remove the bottom handle half from the saw by removing the screws holding it to housing • Attach the new handle following the previous steps in reverse

This is an Original Manufacturer Approved replacement part used on some Compound Miter Saws. This part is made out of Metal and it is Sold Individually. The purpose of this Clamp is to help securing a Blade to the unit.