DW682 (Type 3) DeWALT Planer Jointer - Overview

Included in part number 606883-00

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. This is a standard hardware which has multiple applications based on your tool. For proper use please refer to diagrams. This is a metal torx T20 metal screw which is sold individually.

This is an authentic item that is supplied directly from the original equipment manufacturer for Craftsman Plate Joiners. The Dust bag collects the dust created when operating the saw. The dust bag is made out of fabric and is sold individually. The adapter is sold separately. No tools need to install this part.

This genuine OEM dust adapter in your jointer plate allows you to attach various sizes of vacuum hoses to it for direct dust pick-up. It is part of the dust collection system, you can easily check if the dust adapter is damaged by visually inspecting it for signs of wear or deformations. If you find that it has become loose, fails to crea...Read morete a tight seal, or does not fit the vacuum hose sizes properly, it needs to be replaced. To remove the adapter, firmly pull it out from your machine. When installing the new adapter, insert it into the dust exhaust port on the right side at the rear of the base assembly until it clicks into place. Please keep in mind that this is sold separately from the dust attachment elbow and the dust bag.

Genuine Black and Decker replacement part, this item is sold individually. This Terminal is attached to the cord on all of the tools listed below. It is then attach to the electrical connection of the tool.

This is a genuine replacement part manufactured for use with power tools. The special screw is a versatile fastener used in several applications. The screw is sold individually, please see model diagram for part location and usage.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.