DW505 (Type 1) DeWALT Hammer Drill - Overview

This is an OEM Manufacturer Sourced replacement part used on certain Hammer Drills. Includes One (1) Carbon Brush with wire lead attached. Please note: this brush is sold individually and most tools would use Two of these carbon brushes. It is always best to replace both brushes, even if only one is worn. Carbon brushes are one of the mo...Read morest commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This connecting ball is an authentic manufacturer replacement part used in various power tools. It is a stainless-steel ball that provides a pivot point that allows the attached components to move back and forth smoothly during use. If the connecting ball falls off or becomes loose, worn out, or damaged, the equipment will become unstable or unable to move at all.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Included in part number 585500-00

Included in part number 388808-01

This holder is sourced from the original manufacturer for use in hammer drills. It is yellow in color, and measures 7 inches in length. The holder is responsible for holding the chuck key when it is not in use. The holder fits onto the body of the drill and ensures that the chuck key is easily accessible and safely stored. Replace the hol...Read moreder if it is lost, damaged, or unable to hold the key. The holder and chuck key are sold separately.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. It is made out of rubber and it is sold individually.