DW102-35 (Type 1) DeWALT Boring Machine - Overview

This is a genuine OEM supplied replacement part designed for use with drills/drivers. This screw helps to secure the chuck to the unit. This is a reverse thread, oval-head Torx screw, made out of metal and it is sold individually. Requires a Torx screwdriver to install or remove this screw.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

Included in part number 283502-00

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This is an authentic replacement part that has been OEM sourced to be used with drills and drivers from DeWalt and Black & Decker. The chuck attaches to the spindle assembly. The chuck is used to act like a vise that secures the drill bits and driver bits. The key is used to tighten and loosen the chuck. These items are sold together.

This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic Black & Decker replacement part. The terminal is designed by the manufacturer for use in drills, screwdrivers, and shears. This part is made of metal, and is used to create an electrical connection within the machine. You may require a screwdriver or Allen wrench and pliers when replacing this part. This item is sold individually. Included in part number 450562-00

This holder is sourced from the original manufacturer for use in hammer drills. It is yellow in color, and measures 7 inches in length. The holder is responsible for holding the chuck key when it is not in use. The holder fits onto the body of the drill and ensures that the chuck key is easily accessible and safely stored. Replace the hol...Read moreder if it is lost, damaged, or unable to hold the key. The holder and chuck key are sold separately.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. Included in part number 605511-00