DW008 (Type 1) DeWALT Reciprocating Saw - Overview

This is a Genuine Manufacturer Sourced replacement part designed for use with Makita Miter Saws. This spring is an important part of the tool-less blade clamp assembly. This Torsion Spring is made out of Metal and it is sold individually. Replacing this item you would need a Screwdriver and Pliers.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This blade clamp collar is an authentic OEM component. It is specially made for Black and Decker and DeWALT reciprocating saws. Over time it may wear out, get damaged or simply lost eventually requiring a replacement. This high-quality blade clamp collar is made of durable plastic and is sold individually. Refer to the owner's manual and ...Read morethe diagrams for your specific model for the correct application. You would need a screwdriver to take the housing apart in order to replace this component.

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This is a genuine OEM sourced replacement part designed for use with a variety of power tools. This is a standard hardware which has multiple applications based on your tool. For proper use please refer to diagrams. This is a metal torx T20 metal screw which is sold individually.

This brush ring is an OEM from DeWALT. Compatible with mostly saw devices, the plastic brush ring has been designed to secure carbon brushes. This component is fitted onto the magnet ring. A screwdriver and an Allen wrench are needed in the removal and repair. This part is sold individually.

This is a genuine OEM sourced replacement part that is intended to be used with reciprocating saws from DeWalt and Black & Decker. The metal clamp pin fits into the gear case. The pin is used to support the blade clamp assembly. This item is sold as an individual replacement part.

This screw is commonly used on a variety of power tools. It is a genuine OEM sourced replacement part. Please make sure to check appropriate diagrams for correct location and use of this screw. Includes one pan head screw per order. You will need a screwdriver to install or remove it.

This authentic OEM slider is sourced from the original manufacturer for use in reciprocating saws. It has a width of approximately 1/3 inches and a length of 0.75 inches. The slider is a part of the drive system, and it moves back and forth, allowing the blade to cut through materials. The slider may wear down, or become dislodged over ti...Read moreme, leading to blade instability and inefficient cutting. Begin the repair by removing the saw battery or disconnecting it from the power source. Remove the saw casing and locate the slider in the gear case. Carefully remove the old slider and position the new one in its place. Ensure it is securely fitted and reassemble the equipment.

This is a genuine manufacturer-sourced part which is specially designed for use with DeWALT reciprocating saws. It is an identical replacement for a missing or damaged lever that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and use of this part. Keep i...Read moren mind this high-quality item is made of durable plastic with metal and is sold individually.