Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installat...
This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising th...
This part is sold individually. This nut can be found in various appliances including a dishwasher, air conditioner, washer, dryer, range/cooktop, oven, freezer, range hood, and refrigerator. There is...
Ordered gasket 13 may, received in mail 27 may. Enlarged instructions for easy reading. Removed sliding drawers from inside dishwasher removed door panel and panel at bottom of door to expose nut holding bottom clip removed philips head screw holding bottom clip and used flat blade screw drive to pull gasket fasteners (clips) holding o
... Read moreld gasket in place. Removed old gasket. Installed new fasteners on new gasket, did not need to use plyers to install clips installed gasket junction wire at bottom of gasket and formed gasket to fit dishwasher, installed new gasket on fasteners in dishwasher used handle end of screwdriver to push clips in place, reinstalled new bottom wire clip and used 1/4 in ratchet with socket to secure nut on end of screw holding bottom clip in place. Put slideing drawers back in dishwasher door closed and latched ok so I washed a small load of dishes to check for water leak. No water leak reinstalled door panel and bottom panel on dishwasher.
I removed all of the clips, that held the rubber seal inside the basket. I then replaced the new rubber seal with new clips. Very easy. The instructions were very helpful.
