Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is an open lever for a microwave. It allows the microwave door to open when prompted. When you push on your door latch lever, it contacts the door latch assembly and releases the hooks that lock ...
This oven lamp is temperature rated to be placed inside your oven and illuminate when the door is open. Please consult proper instructions when installing.
This is called a magnetron and it is to be used in your microwave. The purpose of this part is to generate energy and heat for your appliance. This piece is 6 inches long, 6 inches wide, and 5.5 inche...
It took more than 2 hours to do this extremely delicate surgical type procedure! First I had to run to buy beer and chips to make sure I had all the necessary supplies needed. I opened a beer and surveyed the job.I carefully removed the crappy old waveguide cover, and had another beer while opening the package of the new waveguide cover.
... Read moreI then installed the new waveguide and proceed to have a few more beers while I admired my work and the awesome new waveguide from Part-Select. Later I put it to the test and heated up some left over buffalo wings, had a couple more beers and went to bed a happy man with the piece of mind that my new waveguide was up for the job!! Thanks Part-Select!
Unplug. Remove hood. Ground capacitor. Photograph wiring. Remove magnetron. (2 wires, 4 screws). Replace and reassemble. Dispose of old unit. If you are ordering parts and are not into testing circuits order a new diode and difuser card as well. Replace all three.
