This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer unit. Please note that this dryer leg is sold individually.
This door seal is a genuine replacement part for LG dryers. It is a gray, rubber seal that fits around the the opening of the dryer door. It is responsible for creating an airtight seal when the dryer door is closed. This seal helps prevent heat from escaping from the dryer drum during use. It also helps prevent lint, which is produced du...Read morering drying, from escaping into the laundry area. Over time, it is normal for the door gasket to experience wear and tear, leading to issues such as heat loss, and inefficient drying. It is recommended to replace your door seal if it is showing visible signs of damage or if it can no longer remain attached to the door.
This dryer side vent kit lets you vent the exhaust to the side or bottom of your dryer instead of the default rear position. Included in the kit are 2 straight aluminum foil outlet ducts, each 4 inches wide, along with 1 duct elbow, 1 cover plate, 1 screw, and an instruction sheet. This is helpful for flexible installation in areas where ...Read morerear venting is not possible or practical. All parts are genuine replacements from their original manufacturer.
This grey drying rack fits inside your front load dryer. It is an accessory used to dry items that should not tumble, like shoes, stuffed animals, pillows, or other delicate items. It provides a stationary surface for these items to rest on while air circulates. The rack is 27 inches wide and can be attached inside the dryer drum. This genuine OEM rack is sold individually.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Door would not shut completely.
9 of 13 peoplefound this instruction helpful.
James from WIMBERLEY, TX
Very Easy
Less than 15 mins
Screw drivers
After replacing the locker assembly (female) on the machine, The door strike(male) was hitting well below the locker. I realized that the screws holding the door hinge were loose. Tightening them brought the strike up far enough to engage the locker, although it still hits a bit low. That might have been the real problem, not the latch, s
... Read moreo check the hinge before you order the latch parts.
Dryer work but wouldn’t shut off when finished cycle, had to shutoff from breaker
4 of 7 peoplefound this instruction helpful.
joaquin from MIAMI BEACH, FL
Very Easy
Less than 15 mins
Screw drivers
With a thin flat screwdriver I was able to pry out the old door switch, I replaced it with the new door switch, pushed back in dryer and so far is working since I installed a month ago.
Was this helpful?
Thank you for voting!
Dryer door latch broken
3 of 4 peoplefound this instruction helpful.
Paul from OVERLAND PARK, KS
Very Easy
Less than 15 mins
Screw drivers
Part showed up in 2 days and repair took 2 min. Very easy. Thank you!!