DCS371B (Type3) DeWALT Band Saw - Overview

It is a genuine manufacturer approved replacement wheel tire which is specially designed for Dewalt band saws. Its purpose is to provide grip for the saw blade. When putting the tire on a band saw wheel, it may seem too small but it is not. band saw tires will typically come approximately 2 or more inches smaller than the Tire you're repl...Read moreacing. As the tire ages the rubber will harden and allowing the blade to slip. You would need to put the new tire in hot/warm water to heat the tire enough to make it pliable enough to stretch. Its preferred to use two people in the stretching process. This part is made out of rubber and is sold individually.

This authentic DeWALT replacement part is found in assorted band saw types. Bearings are moving parts that facilitate rotational motion and position of various shafts/axles. As high wear components, bearings are replaced relatively often. Sold individually.

This is an authentic DeWalt replacement part manufactured for use in portable band saws. This metal roller allows the blade to move through the guides. The roller is sold individually, although four are required.

This is an OEM part sourced directly from the manufacturer. The idler wheel assembly is designed for use in DeWALT band saws. This part is made of high-quality plastic with a metal insert, and is used to hold one end of the saw blade and allow it to move easily. You may require an Allen wrench or hex key when replacing this part. This item is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The drive pulley is commonly found in DeWALT band saws. This part is made of high-quality plastic and metal, and is used to transfer power from the motor to the saw blade. You may require an Allen wrench when replacing this item. The drive pulley is sold as an individual replacement part.

This is a genuine DeWALT replacement part. The bearing is designed by the manufacturer for use in band saws. This part is made of metal, and is placed in the guide to allow components to spin freely. You may require a screwdriver or wrench when replacing this item. This part is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The blade back up guide is commonly found in DeWALT band saws. This part is made of metal, and is used to hold the bearing that the blade runs along. You may require a screwdriver or Allen wrench when replacing this item. The blade back up guide is sold as an individual replacement part.