DC411KA (Type 2) DeWALT Miter Saw - Overview

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on t...Read morehe tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an authentic replacement part that is sourced from the original manufacturer for use with hedge trimmers. The special screw is commonly used to secure the front guard assembly. This screw is sold as an individual replacement part, please note four screws may be required.

This is an Original Manufacturer Sourced replacement part used on Dewalt Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Hex Hole Flange Nut is to hold the Grinding Wheel to the Spindle Shaft. You would need Hex Wrench to secure this part.

This replacement guard is a genuine Dewalt item, not an aftermarket equivalent. It is supplied by original equipment manufacturer for use with angle grinders. This part helps to protect the user from the dust and trimmings. Never operate grinder without a guard on, it is extremely dangerous. This part is made out of metal and it is sold i...Read morendividually. This guard comes with a latch mechanism making it very easy to install or remove without the need for any tools. (Enclosed Top)

This wrench is an OEM direct from Craftsman for angle grinders. This part helps the motor shaft stay in place when the user pulls out or replaces the grinder disc. It is recommended to review your models diagram to verify the parts compatibility. This part is made of metal and sold individually.

This is a genuine Dewalt replacement part, it is sold individually. The 633257-00SV is used in conjunction with the 636226-00 Nut, to secure grinding wheels and cut-off wheels for the models shown below. It has a 5/8" bore.