D55155 (Type 1) DeWALT Compressor - Overview

It is an OEM component which is designed for use with air compressors. This special nut sleeve assembly secures the pressure relief tube to the pressure switch. It is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. One durable metal nut sleeve assembly is included. A wrench will be needed t...Read moreo perform this repair. Check the appropriate diagrams for your model to ensure the proper replacement procedure. Make sure to drain the air before starting this repair.

This is a genuine OEM approved replacement part designed for use with a variety of air compressors. One quarter turn to fully open/close this drain valve. This part is made out of metal and it is sold individually.

This is a genuine OEM regulator repair kit designed for Dewalt air compressors. It contains all the necessary parts to repair a regulator on your air compressor. Over time internal parts of the regulator will wear out and would need to be replaced. Replacing these items you would need a screwdriver and pliers.

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread, and a hexagonal head for increased stability and security. It allows the compressor to easily start in cold conditions by releasing air pre...Read moressure from the compressor head or the discharge line which reduces the amount of power needed for the motor to start. Once the compressor starts and the pressure in the tank increases, the valve closes and allows pressure to build. If the valve is faulty, the compressor motor will struggle to start, overheat, or trip the circuit breaker. Disconnect the compressor from the power source and open the drain valve to depressurize the tank. Disconnect the pressure switch line from the valve and unscrew the valve using a wrench. Thread the new valve into place and be careful not to overtighten it. Reattach the pressure switch line and close the drain valve to complete the repair.

This is a genuine OEM part. The Porter Cable nipple (1/4-18NPT X 1) is constructed of high-quality metal, and is compatible with many air compressors. This part secures the manifold to the compressor tank. An adjustable wrench set is helpful in making the repair. This part is sold individually.

Included in part number 391106-13

This replacement gauge is an authentic OEM sourced item designed for Dewalt air compressors. The gauge registers pressure readings and allowing user to maintain the needed pressure. This metal gauge is sold individually. Dial reads 0-200 PSI. You should only need a wrench when replacing this gauge.