D55151 (Type 1) DeWALT Compressor - Overview

Frequently referred to as a Drain Plug, this Drain Valve is used to drain any condensation that has collected inside the tank to prevent the tank from rusting. It is not part of a kit or assembly, is sold individually, made of brass, is gold, and will be found at the bottom of the air tank. This part will need to be replaced when it is ...Read moreno longer able to provide a proper seal, or if it is visibly worn or damaged. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This is a genuine OEM replacement part designed for use with a variety of power tools. It is made out of metal and it is sold individually. It is a standard hardware which has multiple applications based on your tool. You would need a wrench to tighten/loosen this nut.

This cold start valve, also referred to as an unloader valve, is supplied by the original manufacturer for use in electric air compressors. It has a length of 0.63 inches, a 1/8-inch male pipe thread, and a hexagonal head for increased stability and security. It allows the compressor to easily start in cold conditions by releasing air pre...Read moressure from the compressor head or the discharge line which reduces the amount of power needed for the motor to start. Once the compressor starts and the pressure in the tank increases, the valve closes and allows pressure to build. If the valve is faulty, the compressor motor will struggle to start, overheat, or trip the circuit breaker. Disconnect the compressor from the power source and open the drain valve to depressurize the tank. Disconnect the pressure switch line from the valve and unscrew the valve using a wrench. Thread the new valve into place and be careful not to overtighten it. Reattach the pressure switch line and close the drain valve to complete the repair.

It is an authentic DeWALT part that is supplied by the original manufacturer for air compressors. The regulator is an important component which allows a user to adjust the air pressure. It is an identical replacement for a missing or a damaged part that was installed on a new unit. To ensure the correct repair procedure, refer to the owne...Read morer's manual and the parts diagrams for your model. The regulator consists of the durable metal body, the gauge, and the plastic knob. A wrench set will be needed to replace this part. Make sure to unplug the air compressors from the power source and drain the air from the tank before starting this repair.