D2002HPV5 Rolair Compressor - Overview

This is an authentic Rolair replacement part manufactured for use with air compressors. The regulator is used to adjust the amount of pressure that builds in the tank. This regulator is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine OEM approved replacement part designed for use with Rolair compressors. The pressure switch is a mechanism which communicates to your compressor when to stop and when to start building up pressure. There are multiple reasons a pressure switch could be leaking air. To complete this repair you would need: wrench set, nut ...Read moredriver set and a thread-sealing tape. • Shut off the electricity and drain the air tank • Remove the tank pressure gauge • Remove the pressure switch tube • Remove the pressure regulator assembly • Disconnect the wires • Remove the safety valve • Install the new pressure switch • Reinstall the safety valve • Connect the wires • Reinstall the pressure switch tube • Screw the pressure gauge onto the new pressure switch and tighten the gauge firmly • Test the air compressor

This authentic manufacturer-sourced component is specially designed for use with Rolair hand carry compressors. The gauge registers pressure readings inside the tank and allows you to maintain the needed pressure. It is an identical replacement for a missing or a faulty part that was installed on a new unit. Please make sure to refer to t...Read morehe owners manual and the appropriate diagrams of your model for the correct location and application of this gauge. Keep in mind this high-quality component is sold individually. Note, this is a back mount gauge.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Rolair compressors. The safety valve is designed to keep the tank from over-pressurizing, unfortunately, over time it may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality part is made of durable me...Read moretal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component.

This is an authentic replacement part sourced directly from the manufacturer. The piston assembly is commonly found in Rolair compressors and pumps. This part is made of metal, and includes the piston, piston pin, and two piston pin retainers. You may require pliers and a screwdriver or Allen wrench when replacing these parts.

This is a genuine replacement part which is sourced directly from the original equipment manufacturer for Rolair pumps. The connecting rod is connected to the crankshaft to move the piston within the cylinder. Lack of oil will allow the rings to contact the cylinder, causing scoring, and eventually, seizure of the engine. Dirt in the cyli...Read morender will act like sandpaper, quickly wearing away the piston rings. Using old or stale fuel will cause varnish build-up, which will eventually 'glue' the rings to the piston. Because the rings seal against the cylinder, any of these conditions will often damage the cylinder. As such, whenever you are investigating with a piston ring problem, you should also carefully inspect the cylinder for damage. You may require pliers and a screwdriver or wrench when replacing this item. This high-quality item is made of durable metal and is sold individually.