My Orders
D1401TB (ASTEEUS) LG Dishwasher - Overview
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$18.22
In Stock
Hinge Cable
Part #4933DD3001B
This dishwasher door hinge cable assembly connects the door to the spring. The door hinge cable and the door spring apply tension to the door to prevent it from dropping open too quickly. This part contains two plastic pieces which are approximately 2 inches in length by 3/4-inch in width, as well as a rope portion that measures approxima...Read moretely 8 inches in length. When beginning this repair, be sure to use caution when replacing the door hinge cable. The spring to which the door hinge cable attaches is under tension and could snap. This part is sold individually.
Read less
$15.00
In Stock
Dishwasher Roller Assembly
Part #4581DD3003C
The dishwasher roller assembly connects to the dishrack, and is located in the lower level of the dishwasher. It allows the dishrack to easily slide in and out. If the lower rack keeps falling off the track in your dishwasher, makes noises, the door will not close, or the dishes are not getting clean, then it is best to replace it for mor...Read moree security. A flat blade screw driver is the only tool needed for this installation. Open the lower dishwasher rack and remove retaining tabs from both ends of the rack and slide it out. Locate the older roll assembly, remove it and replace the rollers. Remember to put the tabs on each side back before sliding it back in. Make sure the dishwasher is off before starting this installation project.
Read less
$29.47
In Stock
Dishwasher Hinge Spring
Part #4970ED4004G
The door spring, used in dishwashers, adds tension to the door through the door hinge to keep it from opening too fast. If you have a door latch failure or your washer door drops too quickly when opened, it is best you replace this part to fix the problem. Refer to the manual provided by the manufacturer for installation instructions and ...Read morefurther repair guidance. Unplug your dishwasher from the power source before you begin this repair project as a safety precaution.
Read less
$105.35
In Stock
MOTOR ASSEMBLY,AC,PUMP
Part #EAU61383518
On a washer, this part is used for circulating the water. On a dishwasher, it is used for draining the water during operation. If you notice your appliance is not draining properly, the circulation pump motor may need to be replaced. If this part is for your washer, you may notice your clothes are not cleaning properly. In your washer, to...Read more access this part you will need to remove the entire front panel. The circulation pump is 120 volts and 30 watts. The part is white in color and is sold individually. This OEM part comes directly from the manufacturer.
Read less
$65.73
In Stock
Gasket
Part #3920DD3005H
This dishwasher door gasket is designed to form a secure, watertight seal around the tub, preventing leaks and enhancing overall wash efficiency. Constructed from flexible, heat-resistant black rubber, it withstands temperatures up to 150°F and resists wear over time. By maintaining a tight seal, the gasket ensures that water and steam re...Read moremain contained within the dishwasher during operation, contributing to more effective cleaning cycles and reduced energy waste. A worn or damaged gasket can lead to water pooling, inefficient washing, and potential damage to surrounding cabinetry. Replacing it restores proper function and helps extend the appliance’s lifespan. Installation is straightforward, requiring the gasket to be pressed into the door channel for a snug fit.
Read less
$15.00
In Stock
Pump Gasket
Part #MFZ32863101
This is a pump gasket, also known as a pump housing seal, for a dishwasher. The gasket is fitted around the edge of the pump, preventing leakage between the pump housing and the filter housing. Located at the bottom of the dishwasher, the pump circulates and drains water from the dishwasher. Age and dishwasher detergents can dry out the p...Read moreump gasket and cause it to fail and leak. Leak from the pump is not always noticeable until you remove access panels from your appliance. This part is made of rubber and is black in color. It is an OEM part from the genuine manufacturer.
Read less
$44.23
In Stock
No Longer Available
Accessory Assembly
Part #5001DD4001A
This is an accessory assembly, otherwise known as a mounting bracket kit, for a dishwasher. This kit includes two brackets, a hose clamp, and two screws. The brackets are perforated so they can be cut or broken to the desired length if they stick out from underneath the countertop. The accessory kit is used to mount the dishwasher to the ...Read moreside of the cabinet or underside of the countertop, depending on your appliance. This kit can be used with both top or side mounting applications. Be sure to use work gloves when completing this repair to avoid injury. This is a genuine replacement part.
Read less
$52.67
In Stock
Drain Hose Assembly
Part #AEM69493807
Replacement dishwasher drain hose. Per the manufacturer if the drain hose being replaced does not have the vent tube going to the water inlet assembly a new water inlet will be needed.
$53.20
In Stock
Diverter Motor - 120V 60Hz
Part #4681ED3001D
This diverter motor, or stepper motor, controls the movement of the spray arms in your dishwasher. It directs water between the drain pump and the spray arms by turning a check valve inside the pump, managing the flow of water to these spray arms. This diverter motor runs on 120 volts and 60 Hz. When this motor fails, the dishwasher will ...Read morenot wash or drain properly. Please keep in mind that this genuine OEM replacement part is sold separately from the spray arms.
Read less
No Longer Available
$76.17
In Stock
Dishwasher Locker Assembly
Part #4027ED3002J
This genuine dishwasher door latch locker assembly is designed to keep the door securely closed during operation, ensuring a proper seal and preventing water leaks. Located at the top of the dishwasher door, it plays a critical role in maintaining safe and efficient performance. If the latch is broken or misaligned, the dishwasher may fai...Read morel to start or leak during a cycle. This OEM part, manufactured by LG, is built to meet original specifications and restore reliable functionality. It’s an ideal solution for homeowners experiencing issues with a door that won’t lock or seal properly. Installation is straightforward for DIYers: unplug the dishwasher, shut off the water supply, and wear gloves for safety. Once installed, the latch ensures the door remains firmly shut throughout the wash cycle, helping prevent accidental openings and water damage. Always confirm compatibility with your model number before purchasing to ensure a proper fit.
Read less
Common Symptoms of the D1401TB
How this model fails, and the parts that fix it.
Leaking
Fixed by
these parts
these parts
Show All
Door latch failure
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Will not drain
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Door was very heavy due to spring problem
7 of 7 people
found this instruction helpful.
Turn off the power at breaker box. Disconnect the power at dishwasher since I needed to pull the unit all the way out of the cabinet to get to screws on the back side for this model. Find and remove the screws to the cover. Remove cover. In my case, the rope on the connector assembly had snapped. I replaced spring and connector identicall
... Read more
y to functioning side. Did need a pair of pliers to provide enough tension on spring to install. Reconnected cover and power and moved back into the cabinet. Easy repair and my wife wondered why I hadn't done it sooner.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!