D110 - Overview

This spring tine is a manufacturer-approved replacement part for your power rake. This part attches to the shaft of your power rake, and can commonly bend or break. This spring tine is sold separately from the sleeve. Make sure to disconnect power to the unit before beginning this repair, and wear work gloves.

This part is the replacement tine clamp for your dethatcher. It is made of metal and is approximately 3 inches long and 1 inch wide. The clamp has a small round hole in either end with a diameter of approximately ¼ inch. A tine clamp is designed to secure the tine for your dethatcher, and the main reason to replace it is if the old tine c...Read morelamp is broken or missing. This item is sold individually, and the hardware to secure the tine clamp is sold separately. This is a genuine OEM part sourced directly from the manufacturer.

This is an authentic OEM part. The spring tine with sleeve is composed of metal and plastic, and is compatible with many power rake devices. This item is secured to the tine clamps, and is sold individually. A wrench and a pair of pliers are often needed in making the replacement.

This genuine decal (Decal, Bluebird w/Logo 15.5") is 15.5 inches, and made of a clear sticky paper.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

This OEM decal is clear and made of a sticky paper.

This hair pin is an OEM direct from Husqvarna. Compatible with many lawn tractors, the metal pin helps to secure the hitch pin and the height adjustment plate. This item is sold individually. A wrench, screwdriver and pliers may be helpful with the removal and replacement.

This is an OEM replacement part for Bluebird aerators. This warning label contains information in regards to the aerator. To replace the label requires no tools, simply peel off the old label and stick the new one into place on the aerator. This part is made of plastic and is sold individually.

This is an authentic manufacturer sourced replacement part designed for use with drills. This chuck key tightens and loosens the jaws of the chuck. This item is made out of metal and it is sold individually.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with lawnmowers, stump grinders, dethatchers, aerators, and power rakes from Husqvarna, Bluebird, Poulan, and Jonsered. The washer is used with different types of equipment and the application of the washer can vary based on the model of the machine. This washer is priced as a single item.

Genuine Bluebird replacement part, this item is sold individually. The purpose of the 539108555 Bolt is to secure the 539091111 Spring Tine W/O Sleeve to the tine shaft of the Bluebird models listed below.