CTF21GBC Hotpoint Refrigerator - Parts

This kit features a 5-blade plastic evaporator fan blade that rotates CCW and measures 4.5-inches in diameter and has a 3/8-inch-tall shaft. This kit also has a metal compression ring that secures the fan to the evaporator. The evaporator mechanism is normally located in the freezer and is responsible for pulling the warmer air over the c...Read moreondenser coils, cooling it off and then blowing and circulating that cooler air through the rest of the refrigerator. If the freezer compartment has a frost buildup or if there is a lack of cooling and airflow in your refrigerator, this fan likely needs to be replaced. To replace your evaporator fan, you will likely need a screwdriver and a set of pliers and check your user manual for the exact location of your evaporator fan.

This refrigerator defrost thermostat will cut out at 55 degrees F and kick back in when the temperature drops to 35 degrees F. It comes with connectors and the mounting brackets.

This condenser fan motor operates in a clockwise fashion. The fan itself has two 1/4 inch spade terminals. It carries 2 watts and 115 volts. This motor NO longer comes with cover for terminals.

The defrost control in your refrigerator acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater, keeping your refrigerator at the appropriate temperature. If you notice that your refrigerator seems too warm or too cool, you may need to replace the defrost control. This part is...Read more made of white plastic and contains 4 metal prongs that connect to your refrigerator. This part is sold individually. The defrost control is located at the back of your refrigerator, inside the control housing. To access this part, you will need to unhinge your light cover, and disconnect the air inlet assembly from the control housing.

This evaporator fan motor operates in a counter clockwise fashion. This motor's stack is 3/8 of an inch, and the motor has two terminals: one on the right side, and one on the left side. Use this evaporator fan motor for your GE brand refrigerator.

This single outlet valve comes with a gasket, and is intended for refrigerators that have ice makers which make round ice cubes. If the ice maker is still not working properly, the issue could be that you have a damaged, or faulty water inlet valve. The water inlet valve supplies the water needed to the ice maker. Before you decide to rep...Read morelace this part, turn the household water supply to this valve off, and remove the input tubing to see if it is clogged. If it is, clear the blockage to allow water back into the ice machine. Remember to disconnect the power and water supply to your refrigerator before beginning this repair.

This part maintains the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process.

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

This newly redesigned icemaker seal kit comes with a new shaft, seal and screw.

This replacement ice maker assembly is used on many of GE's refrigerators. This assembly makes round ice cubes, but does not come with a new feeler arm. You will have to re-use the feeler arm from your old ice maker assembly.