Models > CTF14BJB

CTF14BJB Hotpoint Refrigerator - Overview

Sections of the CTF14BJB

[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Light Switch – Part Number: WR23X10725
Light Switch
★★★★★
★★★★★
(59)
PartSelect #: PS8758429
Manufacturer #: WR23X10725
The interior light of your refrigerator is controlled by a switch that is activated when the door is opened and closed. If your refrigerator light will not turn on, there could be an issue with the sw...
$8.56
  In Stock
Defrost Timer - 120V 60Hz – Part Number: WR9X502
Defrost Timer - 120V 60Hz
★★★★★
★★★★★
(7)
PartSelect #: PS310869
Manufacturer #: WR9X502
This defrost timer will cycle for 25 minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange. If you...
$93.29
  In Stock
Ice Cube Tray – Part Number: WR30X311
Ice Cube Tray
★★★★★
★★★★★
(1)
PartSelect #: PS300166
Manufacturer #: WR30X311
14 Cube.
$8.06
  In Stock
Power Cord – Part Number: WR23X10300
Power Cord
★★★★★
★★★★★
(3)
PartSelect #: PS759476
Manufacturer #: WR23X10300
This heavy-duty cord has a three-pronged plug (2 electrical, 1 grounding). The power cord supplies power to your refrigerator, allowing it to keep the contents inside cool. There could be an issue wit...
$29.54
  In Stock
Defrost Thermostat Kit – Part Number: WR50X50
Defrost Thermostat Kit
PartSelect #: PS303516
Manufacturer #: WR50X50
The defrost thermostat included in this kit cuts out at 50 degrees Fahrenheit and kicks back in when the temperature drops to 30 degrees Fahrenheit. Also included in this kit are two interchangeable b...
$22.23
  In Stock
Tubular Fastener – Part Number: WR2X4990
Tubular Fastener
PartSelect #: PS298031
Manufacturer #: WR2X4990
$10.53
  Special Order
R134 DRIER – Part Number: WR86X25269
R134 DRIER
PartSelect #: PS12727537
Manufacturer #: WR86X25269
The filter dryer filters refrigerant that travels through the sealed system of the refrigerator.
$62.27
  In Stock
FAN BLADE – Part Number: WR60X139
FAN BLADE
PartSelect #: PS304702
Manufacturer #: WR60X139
$66.84
  In Stock
DISCONTINUED – Part Number: WR8X5202
DISCONTINUED
PartSelect #: PS310410
Manufacturer #: WR8X5202
  No Longer Available
INSULATOR – Part Number: WR2X9500
INSULATOR
PartSelect #: PS299881
Manufacturer #: WR2X9500
$49.47
  Special Order
DOOR GASKET – Part Number: WR24X5234
DOOR GASKET
PartSelect #: PS297118
Manufacturer #: WR24X5234
$73.90
  Special Order
I.D. PANEL – Part Number: WR77X5659
I.D. PANEL
PartSelect #: PS307573
Manufacturer #: WR77X5659
$521.90
  Special Order

Questions And Answers for CTF14BJB

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the CTF14BJB

[Viewing 10 of 10]
Light not working
Fixed by
these parts
Fixing
Show All
Fridge too warm
Fixed by
these parts
Fixing Fixing
Show All
Freezer section too warm
Fixed by
these parts
Fixing
Show All
Freezer not defrosting
Fixed by
these parts
Fixing
Show All
Will Not Start
Fixed by
these parts
Fixing Fixing
Show All
Fridge and Freezer are too warm
Fixed by
these parts
Fixing
Show All
Leaking
Fixed by
these parts
Fixing
Show All
Fridge runs too long
Fixed by
these parts
Fixing
Show All
Noisy
Fixed by
these parts
Fixing
Show All
Freezer too cold
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sticking Light Switch
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the switch could be pulled out further each time the catch clip was depressed to the next detent. Then I used the screw driver on the left site to encourage the switch past the detents on the left and very quickly the switch was out of the mount. The wires from the refrigerator pulled out with the old switch. I unplugged the old switch from the wires and plugged in the new switch and shoved the new switch back into the mount, wiggled it a couple of times to make sure it was secure and the job was done. Once I applied the vise gripes at first, the whole job took less than a minute.
Parts Used:
Light Switch
  • Jonathan from Lilburn, GA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
116 of 144 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
refrigerator was not cooling but the freezer worked fine.
My husband put on the defrost timer. At first I thought the part was not going to fix the problem. After about 5 hours my refrigerator was still warm. I went to work and when I got home that evening my refrigerator was cooling and down to 28 degrees. So if you replace this part wait at least 12-24 hours. Give it time to stablize. My husband says it has to go through its cycle. It works on a 24 hour timer. My refrigerator is working fine and this has saved me alot of money. My husband says, once you put on the timer you may have to use a flat screwdriver and turn the small dial clockwise one click to start it. He removed the kick grill and replaced the part. Dont forget to shut breaker off to replace this part. Turn power back on and start the timer. We are so happy that we now have a working refrigerator.
Parts Used:
Defrost Timer - 120V 60Hz
  • Wanda from Cabins, WV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
86 of 100 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
display showed dE
popped off front grille, removed 2 screws for bracket, then had to remove one screw for timer. unplugged old timer, reversed procedure, all works.
Parts Used:
Defrost Timer - 120V 60Hz
  • Nancy from Hamburg, NY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver
74 of 116 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!