CT9070SH2SS General Electric Wall Oven - Instructions

After opening the Oven door, I removed the glass cover to view and locate the bulb, at the inside, top front of the Oven. Removed the burnt out bulb by pulling it in a forward motion towards the front of the Oven, slid the new bulb into place and the Oven is again functional.

I used a Trox bit to remove one screw, replaced the oven sensor and reinstalled the screw. The whole project took less than 5 minutes.

Replaced upper cooling fan and board on double oven by removing covers on top and back.

there was one screw holding it on the back wall of the oven. It was easy enough that my daughter installed it with my guidance.

This item worked as described. I paid more for this 'oem' probe than the generic 1 because i didn't want to chance it not working as others have reported.
- works great. tested it....snaps in, reads correctly, snaps out.

Threw the old one out - plugged the new one in. Steak came out just as ordered - medium rare.

Remove oven light lens cover, remove the bulb and replace it with a new one.

Changed the Temperature Sensor as you suggested, but the problem of 40 minutes to reach a temperature of 375 degrees F. remained the same.

Replaced it

Ordered new probe

plug in thermistor when needed