CT436100AV Campbell Hausfeld Compressor - Overview

It is a genuine OEM part that is made for Campbell Hausfeld air compressors. The unloader valve is an important component which allows a user to safely drain the air from the tank. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement to ensure your unit operates properly. Note, this high-quality unloa...Read moreder includes multiple parts however it is sold as an individual component. Check the owner\\\'s manual and the diagrams of your model to ensure the correct installation and application. You will need a wrench set and pliers to perform this repair.

Sourced directly from the manufacturer, this plug is an exact replacement part for a variety of air compressors. This part is sold individually, not as part of a kit or assembly. It is gold, made of metal, and will be found on the pressure switch. This part will leak when it has become defective and will need to be replaced if it is dam...Read moreaged or worn. When you install the part, apply Teflon tape to the threads before tightening it in place. You will need a wrench to complete this repair. Customers rate this repair as Easy.

This genuine OEM replacement nipple is designed for use in air compressors, serving as a critical connector between the pressure switch, the tank, and the regulator. A damaged or corroded nipple can lead to air leaks and inconsistent pressure, affecting overall performance. To check for leaks, apply soapy water to the fittings around the ...Read morepressure switch and watch for bubbles. If replacement is necessary, the process typically involves disassembling the pressure switch. Begin by draining the tank using the valve at the bottom, then remove the coupler from the regulator and unthread the nipple. Access the wire connections by removing the pressure switch shroud, and carefully note the position of each wire before disconnecting them—starting with the motor wire, followed by the cord wires and ground wires. Remove the strain relief, pressure gauge, and the airline connecting the check valve to the switch. Finally, unthread the pressure switch from the tank nipple and remove the nipple itself. When reassembling, it is recommended to use thread tape to ensure a proper seal. This replacement part is sold individually.

This is a genuine replacement part which is supplied by the original equipment manufacturer for use with Ridgid and Campbell Hausfeld air compressors. It helps to regulate the air pressure in the compressor tank by adjusting the knob. In some instances, you will need lower or higher air pressure in the tank and the air coming from the tan...Read morek. Over time parts may wear out and begin to fail eventually requiring replacements. This high-quality regulator is made of durable metal with a plastic knob. Check the owner's manual and the diagrams for your model to ensure the correct installation procedure. You will need a wrench set to remove the old regulator and attach the new one. Make sure to unplug the air compressor and to drain the air from the tank before starting this repair.

The shoulder bolt attaches to the rubber bushing and the roll bar. This item is sold individually and is made of metal. This part is an OEM from Campbell Hausfeld and Husky for use in air compressors. When replacing this bolt a wrench will be needed. It may become broken or stripped and will need to be replaced.

This is an authentic Campbell Hausfeld replacement part. The smart start air filter is designed by the manufacturer for use in compressors. This part is a complete assembly, which is attached to the pump and motor to remove dust and debris from the air. You may require a wrench when replacing this part. This item is sold individually.