CSHS6UGZESS General Electric Refrigerator - Parts

This black freezer door gasket forms a tight seal around the door. It keeps cold air inside and blocks warm, damp air that can cause frost. Replace the gasket if it is torn, hard, loose, or badly bent. Before ordering, clean the seal and check the hinges, door frame, and gasket channel. Confirm fit with the full appliance model and the 37...Read more-by-31-inch size. Soak shipping folds in warm water for 5 to 10 minutes, press the gasket into place, smooth each side, and keep the door closed for several hours.

This DC fan motor moves air across the condenser coils and compressor to help remove heat. A failed motor may cause poor cooling, a hot compressor, or humming and squealing sounds. Before replacing it, clean the coils and check the fan blade, wiring, and air path for dirt or damage. Confirm fit with the full appliance model, 4-pin plug, a...Read morend 11.3- to 12-volt rating. Unplug the refrigerator before removing the rear panel. Keep hands away from the blade, protect the cooling lines, and reinstall the panel before testing the unit.

This is the replacement bucket auger for your refrigerator. It is approximately 20 inches long and 14 inches wide. The bucket auger sits within the ice maker assembly and rotates to push the ice from the ice container into the dispenser chute. If your ice maker bucket is full, but ice is not being dispensed, it is an indication that the a...Read moreuger is damaged. Be sure to disconnect power from the refrigerator before you repair the auger. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This part regulates the humidity of your crisper bins. It does so by opening and closing vents on the bin. If your humidity control is broken or missing, you will need to replace it. This is a genuine OEM part from GE and is sourced directly from the manufacturer.

This is the replacement door stop, also known as a door stop bracket, for your refrigerator. It is made of black plastic, and is approximately 3 inches long and 1 inch wide. The door stop bracket stops the door from opening more than approximately 90 degrees. The stop can occasionally break, and this will allow the door to open more than ...Read more90 degrees. When this occurs, you will need to replace the door stop. This part is sold individually and is an OEM part.

This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.

10-16 pl pnp 5/8 szn - Sold individually.

This part is the replacement fresh food door gasket for your refrigerator. It is made of black rubber and is sold individually. The fresh food door gasket runs along the circumference of your refrigerator’s fresh food door and creates the seal that allows your refrigerator to regulate the temperature inside. If the gasket is worn, stretch...Read moreed, or damaged, your fridge may become too warm, and you may notice the door is sweating. The door also may not open or close properly because of a damaged gasket. To replace the gasket, carefully pull the old gasket out the grooves it fits in around the door. Press the new gasket into the same grooves snugly. This part is an OEM part from the manufacturer.

This genuine OEM screw is designed for use in refrigerators. It measures approximately ¾ of an inch in length.

3 terminal.

This plastic shelf support, or shelf stud connects the shelf to your refrigerator. To replace the shelf support first remove the shelves and drawers from your refrigerator, then remove the damaged or faulty stud before installing the new one. This genuine OEM shelf support has an outside diameter of approximately half an inch.

This dispenser housing supports and encloses the crushing mechanism while directing dispensed contents. Its sturdy design helps ensure smooth operation and consistent performance.