CSE7000ADB Maytag Cooktop - Overview

Diagrams for CSE7000ADB

See every part. Know exactly what you need.

BODY

Parts for the CSE7000ADB

$19.30

Surface Burner Receptacle Kit

★★★★★

(21)

Part #12001676

The tools you will need to replace the surface burner receptacle kit on your range include a Phillips screw driver, and a pair of wire strippers. Before doing this repair, make sure to disconnect your appliance from the power supply and wear work gloves to protect your hands. The surface burner receptacle kit comes with a plastic block, h...Read more

Read less

$7.47

Dryer Screw

★★★★★

(2)

Part #WP90767

This screw is sold individually.

$7.47

Range Screw 632 X 5/16

Part #WP74004005

This screw is well under an inch long, and is made of metal.

Receptacle Mounting Bracket

Part #W10116809

This terminal block mounting bracket is a little over two inches long. It is made of metal.

$7.47

Range Screw

Part #WP7101P309-60

Sold individually.

$7.47

Screw

Part #WP71001171

BREAKER 30 AMP NLA

Part #702008

BREAKER BOT NLA

Part #704165

HARNESS CONTROL **NLA*

Part #04100525

TOP SUPPORT BRACKET **NLA*

Part #04100399

PILOT LIGHT HARNESS **NLA*

Part #04100490

*NLA*WIRE WHITE

Part #04100493

Common Symptoms of the CSE7000ADB

How this model fails, and the parts that fix it.

Element will not heat

Videos related to the CSE7000ADB

Watch our pros, then fix it yourself.

Replacing the Surface Burner Receptacle Kit

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Stove top element not working due to bad receptacle.

196 of 216 people found this instruction helpful.

Richard from Carthage, NC
Really Easy
Less than 15 mins
Pliers, Screw drivers

Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister ... Read more

Read less

Was this helpful?

Burner was out but the burner coil worked on onother burner

10 of 10 people found this instruction helpful.

Richard from Orange, CA
Easy
15 - 30 mins
Pliers, Screw drivers

Replaced receptacle but it was not the problem. After further inspection I believe that the problem is the switch. The switch is on order now from Part Select.

Was this helpful?

burner receptacle burned out

8 of 9 people found this instruction helpful.

Michael from N. Haverhill, NH
Easy
15 - 30 mins
Screw drivers

Worst part of the job was removing the old screws that held the two old rectecles in place for the two burners I repaired. Once the screws were removed cut the wires stripped them and used the porceliean wire nuts provided with the kit. Easy job and good instructions.

Was this helpful?